De Dietrich DHK4400E1 is a kitchen ventilation device that helps get rid of steam and odors. It can be installed with the air outlet on the side or on the top, depending on your kitchen's layout. The device is designed for indoor use only and should not be used to ventilate areas with gas appliances. It is also important to ensure that the room where the device is installed is well aerated, especially if other heat-producing appliances are used simultaneously. The DHK4400E1 comes with all the necessary mounting hardware, including screws, washers, and brackets, for easy installation.
De Dietrich DHK4400E1 is a kitchen ventilation device that helps get rid of steam and odors. It can be installed with the air outlet on the side or on the top, depending on your kitchen's layout. The device is designed for indoor use only and should not be used to ventilate areas with gas appliances. It is also important to ensure that the room where the device is installed is well aerated, especially if other heat-producing appliances are used simultaneously. The DHK4400E1 comes with all the necessary mounting hardware, including screws, washers, and brackets, for easy installation.
Guide d’utilisation
Instructions for installation and use
Montage- und gebrauchsanweisung
Istruzioni per l'installazione e l’uso
Instrucciones para instalación y uso
Aanwijzing voor gebruik en installatie
Installation-Og Brugsvejledning
DHK4400E1
ENGLISH
WARNING
The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy other
than electricity (central heating systems, thermosiphons, water-heaters, etc.).
Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct.
In addition, exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that purpose.
The room must be well aerated in case a hood and some other heat equipment fed with an energy other than electricity
(gas, oil, coal heaters, etc) operate at the same time. In fact the intake hood, disposing of air, could create a vacuum
in the room. The vacuum should not exceed 0,04mbar. This prevents the gas exhausted by the heat source from
being intaken again. It is therefore advisable to ensure the room contains air taps able to ensure a steady flow of
fresh air.
ATTENTION: This appliance must be grounded.
When making the electrical connections, check that the current socket has a ground connection and that the voltage
values correspond to those indicated on the data plate inside the appliance itself.
In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other
device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3 mm,
such separating device ensuring disconnection from the main must be included in the fixed installation. If your unit
features a power lead and plug, position this so the plug is accessible.
Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance.
Thorough servicing guarantees correct and long-lasting operation.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do
not play with the appliance.
To get optimal conditions the air venting pipe should:
– be as short as possible.
– have the lowest number of bends (max bende angle: 90°).
– be made of material approved by local authorities (according to the State).
– have its inner side as regular and smooth as possible.
It is moreover recommended to avoid drastic changes of pipe cross section (recommended diameter: 150 mm).
INSTALLATION
The appliance has been specially designed to extract steam and smells from the kitchen in an efficient and silent way;
it must be installed inside the premises and can be connected to a hood inside the kitchen.
The appliance can be positioned with the air outlet at the side (example Fig. 1 and 2) or with the air outlet above (example
Fig. 3 and4). In all cases, the appliance must always be secured to the floor. Depending on your requirements, select
the most appropriate solution and follow the instructions provided below. To obtain the best from the appliance, we
recommend the installation shown in Figure1.
INSTALLATION WITH SIDE AIR OUTLET:
Installation of the type shown in Fig. 1 (on the vertical of the hood):
Prepare the power supply and hole for air extraction.
Place the drilling template on the floor and superimpose the hole indicated (for side outlet) on that previously made in the
roof; make the 4 holes and fit the 4 anchors provided; also make the hole for the power cable.
Take the 2 metal brackets provided and secure these to the appliance, being careful to ensure they project so that when
fastening, the power cable is able to pass underneath the appliance (Fig. 5).
Fit a hose (T) to the flange of the appliance (Fig. 5).
Fit the 4 rubbers and 4 bushes (provided) in the holes of the brackets (Fig. 6).
At this point, turn the appliance upside down and pass the hose and power cable through the holes previously made; position
the appliance properly and secure it to the floor using the 4 screws and 4 washers (Fig. 7).
Connect the hose to your hood and make all power connections (see “Electrical Connection” chapter).
Installation of the type indicated in Fig. 2:
Prepare the power supply and hole for air extraction.
Remove cap (A) and flange (B) and switch these round (Fig. 8).
Place the drilling template on the floor, drill the 4 holes and fit the 4 anchors provided.
Take the 2 metal brackets provided and secure these to the appliance (Fig. 9).
Fit the 4 rubbers and 4 bushes (provided) in the holes of the brackets (Fig. 6).
At this point, turn the appliance upside down and secure it to the floor using 4 screws and 4 washers (Fig. 10).
Fit a hose (T) to the flange of the appliance (Fig. 10); connect this to your hood and make power connections (see “Electrical
Connection” chapter).
INSTALLATION WITH UPPER AIR OUTLET:
Installation of type indicated in Fig. 3:
Prepare the power supply and hole for air extraction.
Remove cap (A) and flange (B) and switch these round (Fig. 8).
Place the drilling template on the floor and superimpose the hole indicated (for upper outlet) on that previously made in
the roof; make the 4 holes and fit the 4 anchors provided; also make the hole for the power cable.
Take the 2 metal brackets provided and secure these to the appliance, being careful to ensure they project so that when
fastening, the power cable is able to pass underneath the appliance (Fig. 11).
Fit a hose (T) to the flange of the appliance (Fig. 11)
Fit the 4 rubbers and 4 bushes (provided) in the holes of the brackets (Fig. 6).
At this point, turn the appliance upside down and pass the hose and power cable through the holes previously made; position
the appliance properly and secure it to the floor using the 4 screws and 4 washers (Fig. 12).
Connect the hose to your hood and make all power connections (see “Electrical Connection” chapter).
Installation of type indicated in Fig. 4:
Prepare the power supply and hole for air extraction.
Place the drilling template on the floor, drill the 4 holes and fit the 4 anchors provided.
Take the 2 metal brackets provided and secure these to the appliance (Fig. 13).
Fit the 4 rubbers and 4 bushes (provided) in the holes of the brackets (Fig. 6).
At this point, turn the appliance upside down and secure it to the floor using 4 screws and 4 washers (Fig. 14).
Fit a hose (T) to the flange of the appliance (Fig. 14); connect this to your hood and make power connections (see “Electricall
Connection” chapter).
ELECTRICAL CONNECTION:
Direct electrical connection: the input cable must be connected directly to the electrical voltage, (therefore the apparatus
will always work at the maximum speed) fixing the electrical cable of the apparatus directly to the current tap (socket)
connected to a normal ON/OFF switch. Electrical connection to a hood: (Fig.15). The input cable must be connected to
the hood. Find out the box F (placed on the hood) for connecting the hood to the mains. Take off the cable clamp A and
the cover B of the connection box. Fix the cable to the terminal board C. Reassemble the cable clamp A and the cover
B of the connection box.
AFTER SALES SERVICE
Any maintenance on your equipment should be undertaken by:
- either your dealer,
- or another qualified mechanic who is an authorized agent for the brand appliances.
When making an appointment, state the full reference of your equipment (model, type and serial number). This information
appears on the manufacturer’s nameplate attached to your equipment.
WARRANTY (FOR AUSTRALIA)
(Legal instruction)
Young children should be supervised to ensure that they do not play with the appliance.
The appliance is not intended for use by young children or infirm person without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person
in order to avoid hazard.
WARNING : Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.
For service issues, telephone number: 1300
Do not install the product if you see any damage on it.
1. Subject to the “Statement of Standard Warranty
Conditions” this product is covered by the following
Warranty.
TWO (2) YEARS WARRANTY from date of purchase,
covering all parts and labour.
2. The appliance is warranted under normal single family
domestic installation and use, as set out in the
instruction manual, against manufacturing defects
for the Warranty periods shown above.
3. Should service be required under this Warranty, the
purchaser should contact an approved DE DIETRICH
Service Provider during their normal business hours.
4. At no time does DE DIETRICH/MEA have liability for
any freight or transportation costs or for any damage
during transit or for any consequence of failure of
this appliance outside of the normal service area,
unless such limitation of liability is prohibited by
statute.
5. This Warranty excludes replacement of parts required
due to normal wear and tear including light globes.
6. This Warranty only applies, provided the appliance
has been used in accordance with the manufacturer’s
instructions and provided an accident, misuse,
neglect or abuse has not damaged the appliance.
7. None of the above Warranties purport to exclude,
restrict or modify either the application or the exercise
of a right conferred by any applicable Statute.
8. Please complete the details below, which should
be retained for future reference along with your
proof of purchase:
Date of Purchase:..……………………………...........
Model No:……………………….....……………...........
Serial No:………………………….....……….........…..
DE DIETRICH COOKING PRODUCT
WARRANTY (FOR AUSTRALIA)
STATEMENT OF STANDARD
WARRANTY CONDITIONS
(FOR AUSTRALIA)
1. The Warranty only applies provided that the appliance
has been used in accordance with the manufacturer’s
instructions and provided that the appliance has not
been damaged by an accident, misuse, neglect or
abuse of any person other than the manufacturer or
DE DIETRICH/Major Electrical Appliances (“MEA”)
or from faulty installation, mis-adjustment or
tampering by unauthorised persons.
2. When a service inspection reveals the alleged fault
or faults are caused by incorrect operation, contrary
to the instruction manual, and otherwise the appliance
is in good order and working condition, the purchaser
shall be liable for a service fee charged by DE
DIETRICH/MEA or one of its’ Service Providers.
3. If the appliance is used in Commercial Applications
or for Rental purposes, a separate warranty of Twelve
(12) months covering all parts with Three (3) months
on the labour will apply.
4. Subject to the provisions of any applicable statute
this Warranty applies to the original retail purchaser
only and is not transferable.
5. Subject to the provisions of any applicable statute,
at no time does DE DIETRICH/MEA have liability for
freight, transport or travel costs outside normal
service areas.
6. None of the above Warranties purport to exclude,
restrict or modify either the application or the exercise
of a right conferred by any applicable statute.
7. Subject to any Warranties implied by statute, at no
time will DE DIETRICH/MEA or its’ Service Providers
be liable for any economic loss consequent upon
the failure of the appliance.
8. This Warranty is only valid for major appliances
imported and distributed by DE DIETRICH/MEA,
purchased and used in Australia.
12
3
4
T
5
6
7
8
A
B
9
10
T
11
12
T
13 14
T
15
F
A
B
C
04307399/1S
-
1
-
2
-
3
-
4
-
5
-
6
-
7
De Dietrich DHK4400E1 is a kitchen ventilation device that helps get rid of steam and odors. It can be installed with the air outlet on the side or on the top, depending on your kitchen's layout. The device is designed for indoor use only and should not be used to ventilate areas with gas appliances. It is also important to ensure that the room where the device is installed is well aerated, especially if other heat-producing appliances are used simultaneously. The DHK4400E1 comes with all the necessary mounting hardware, including screws, washers, and brackets, for easy installation.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
De Dietrich LZ9616U1 User manual
-
De Dietrich LZ9619U1 User manual
-
De Dietrich LZ9619E2 User manual
-
De Dietrich LZ9600E1 Owner's manual
-
De Dietrich DTI1041XE Owner's manual
-
De Dietrich DTIM1000C Operating instructions
-
-
De Dietrich DTI1053X Owner's manual
-
De Dietrich DTI1049JE Owner's manual
-
De Dietrich DTI1089VC Owner's manual
Other documents
-
Groupe Brandt LZ9619U1 Owner's manual
-
-
-
-
DeDietrich Cooker hood User guide
-
Groupe Brandt DHD109BE1 Owner's manual
-
-
-
-