Defiant DFI-7004-WH User guide

Category
Watches
Type
User guide

This manual is also suitable for

Defiant DFI-7004-WH-G is a motion-activated solar security light that provides bright illumination for outdoor areas. It features adjustable lamp heads for directing light where it's needed, a motion sensor with adjustable sensitivity for customizing the detection range, and a light timer that allows you to set the duration of light after motion is detected. The solar panel requires full, direct sunlight for charging, and the battery provides power for up to 1 minute of light per activation. Easy to install and operate, this light is a reliable security solution for your home.

Defiant DFI-7004-WH-G is a motion-activated solar security light that provides bright illumination for outdoor areas. It features adjustable lamp heads for directing light where it's needed, a motion sensor with adjustable sensitivity for customizing the detection range, and a light timer that allows you to set the duration of light after motion is detected. The solar panel requires full, direct sunlight for charging, and the battery provides power for up to 1 minute of light per activation. Easy to install and operate, this light is a reliable security solution for your home.

HOMEDEPOT.com Please contact 1-866-308-3976 for further assistance.
Quick Start Guide
MOTION SOLAR SECURITY LIGHT
The solar panel requires full, direct sunlight to charge the battery. Clouds, rain, snow, and other weather conditions may not allow
the solar panel to completely recharge the battery. Other obstructions such as buildings or trees may block the sun as well.
When installing the solar panel, make sure it is aimed toward the sun with a minimum amount of obstructions. If possible,
mount the panel facing toward the southern sky.
Refer to the included full instruction manual Use and Care Guide” for installation, safety, and additional information.
Operation
1 Adjusting the lamp heads
The lamp heads may be adjusted left or right and up and
down.
THIS SIDE UP
2 Connecting the solar panel to the light fixture
Adjust solar panel toward the sun for maximum sun
exposure.
Plug solar panel connector into light xture connector.
THIS SIDE UP
3 Determining the motion sensor detection zone
NOTE: When the motion sensor switch is set to the “TEST”
position, the light will operate during the day or night. The light
will stay on for 5 seconds after all motion is stopped.
Slide the switch to the “TEST” position.
Slide the “SENS” switch to the “L (low) position.
Perform a “walk test”: walk in an arc across the front
of the motion sensor.
Watch the light. The light will come on and the red
LED will ash indicating motion has been detected.
Stop, wait for the light to turn off, and then begin
walking again.
Continue this process until the detection zone has
been established.
If needed, gently grasp the motion sensor and move
it from side to side or up and down to adjust the
detection zone.
SENS
5S 1MIN
OFF TEST AUTO
L M H
4 Adjusting the sensitivity
“L – Low range
“M” – Medium range
“H” – High range
SENS
5S 1MIN
OFF TEST AUTO
L M H
SENS
5S 1MIN
OFF TEST AUTO
L M H
5 Adjusting the light timer
OFF – turns light off.
TEST – light operates day or night for 5 seconds after
all motion has stopped. Used for setup.
AUTO – motion activated. Light can be set to stay on
between 5 seconds and 1 minute after all motion has
stopped.
SENS
5S 1MIN
OFF TEST AUTO
L M H
SENS
5S 1MIN
OFF TEST AUTO
L M H
SENS
5S 1MIN
OFF TEST AUTO
L M H
Item # 1005414989
Model # DFI-7004-WH-G
HOMEDEPOT.com Please contact 1-866-308-3976 for further assistance.
INITIAL BATTERY CHARGE
IMPORTANT: Ensure the solar panel cord is firmly attached to the light fixture cord with no space between the two
connectors.
IMPORTANT: The solar panel requires full, direct sunlight to charge the battery. Clouds, rain, snow, and other weather conditions may not allow the
solar panel to completely recharge the battery. Other obstructions such as buildings or trees may block the sun as well.
When installing the solar panel, make sure it is aimed as described below with a minimum amount of obstructions. If possible, mount the panel facing
toward the southern sky.
PRIOR TO USE, the battery will require 2 to 5 days of full sun to completely charge with the control switch in
the OFF position. Plug the solar panel cable into the connector extending from the bottom of the battery case.
If possible, aim the solar panel toward the south and tilt it approximately 50° from horizontal. If the solar panel
cannot be aimed toward the south, then tilt the panel approximately 30° if possible.
Actual operating time will vary depending upon how frequently the light is turned on by the motion sensor.
Solar lighting is not designed to equal standard 120V lighting. The amount of light output is reduced to allow the
sun time to fully recharge the battery between lighting cycles.
Solar collection is only effective in direct sunlight. Every hour the light is on requires a minimum of 16 hours of
sunlight charging. Solar panels collect less than 10% of the sun’s energy.
To ensure the maximum RUN TIME solar performance:
Slide the control switch to the AUTO” position.
Slide the “SENS” switch to the “M” (medium)
position.
Set the time dial HALFWAY between 5S and 1MIN.
SENS
5S 1MIN
OFF TEST AUTO
L M H
Troubleshooting
Problem Possible Cause Solution
The light xture is not
charging.
The solar panel is not
COMPLETELY
connected to the light xture.
Ensure the solar panel connector is fully
inserted into the light xture connector.
There should be NO gap.
The light xture ashes ON
and OFF repeatedly.
The light xture is in TEST mode. Set the light xture motion sensor to
the OFF or AUTO (5 seconds to 1 minute)
setting.
The light xture is charging
but does not come on at night.
The motion sensor is set to the OFF
position.
Set the light xture motion sensor to the
AUTO (5 seconds to 1 minute) setting.
210536-03A
  • Page 1 1
  • Page 2 2

Defiant DFI-7004-WH User guide

Category
Watches
Type
User guide
This manual is also suitable for

Defiant DFI-7004-WH-G is a motion-activated solar security light that provides bright illumination for outdoor areas. It features adjustable lamp heads for directing light where it's needed, a motion sensor with adjustable sensitivity for customizing the detection range, and a light timer that allows you to set the duration of light after motion is detected. The solar panel requires full, direct sunlight for charging, and the battery provides power for up to 1 minute of light per activation. Easy to install and operate, this light is a reliable security solution for your home.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI