2. Home
  3. Home security & automation
  4. Security camera accessories
  5. AETEK
  6. SD-404-V2
SD-404-V2

AETEK SD-404-V2 Installation guide

  • Hello! I've reviewed the AETEK Quick Installation Guide for their surge protectors, including models like SD-101, SD-102, SD-201 and SD-202 and others. This guide provides essential information on installation, cabling, and LED status. These devices protect against lightning and transient voltage, with some models offering modular or Smart IP features. I'm ready to assist you with any questions you might have regarding these products.
  • What type of cables should I use?
    What is the maximum cabling distance between the surge protector and the protected device?
    What does the LED indicate?
Ground screw
PoE Out
PoE Switch
* Make sure the grouning
resistance is lower than
0.5Ω.
< 1 meter
Equip Out
Line In
#1
#2
< 1 meter
LED
Equip Out
Line In
1. Use CAT5e or CAT6 UTP/STP cables.
2. The cabling distance between the surge protector and the protected device should be less than 1 meter.
PoE Surge Protector
Model Description
SD-101 Indoor 10M/100M/1G/2.5G bps surge protector against lightning or transcient voltage
SD-102 Indoor 10M/100M/1G/2.5G/10G bps surge protector against lightning or transcient voltage
SD-201 Outdoor 10M/100M/1G/2.5G bps surge protector against lightning or transcient voltage
SD-202 Outdoor 10M/100M/1G/2.5G/10G bps surge protector against lightning or transcient voltage
SD-404-V2 4-ch Modular 1G/2.5G PoE surge protector
SD-424-V2 24-ch Modular 1G/2.5G PoE surge protector
SD-401-M-V2 1-ch PoE surge Modular for replacement
SD-424-C-V2 19",1U 24-ch chassis
SD-504 4-ch Modular 1G/2.5G Smart IP PoE surge protector
SD-524 24-ch Modular 1G/2.5G Smart IP PoE surge protector
SD-501-M 1-ch Smart IP PoE surge Modular for replacement
SD-524-C Smart IP 19",1U 24-ch chassis
IMPORTANT:
INTRODUCTION
CONNECTION
* 1x surge protector * 1x Quick Installation Guide
PACKAGE CONTENTS
P/N: A625010301G
Quick Installation Guide
LEDs
 LEDdenitions:
OFF when operating normally, ON when out of service life.
SD-101 / SD-102 / SD-201 / SD-202
Allspecicationsaresubjecttochangewithoutnoice.
Copyright © 2021 AETEK INC. All rights reserved.
AETEK INC.
6F, No.192-1, Lien-Cheng Rd., Chung-Ho, New Taipei City, 235, Taiwan,
R.O.C. |T: +886-2-82452822|W: www.aetektec.com|E: [email protected]
LEDs
LEDdenitions:
Fail Red OFF when operating normally, ON when out of service life.
SD-404-V2 / SD-424-V2
SD-504 / SD-524
PoE Out
< 1 meter
PoE Switch
1M
SD-524
SD-101
PoE Surge Protector
PoE VoIP Phone
VoIP IP PBX
SD-201
PoE Surge Protector
PoE Camera
PoE (Data + Power)
SD-504
#12awg.
Ground wire must be
as short as possible
Remove
screws
#12awg.
Ground wire must be
as short as possible
SD-404
#12awg.
Ground wire must be
as short as possible
PoE Switch
1M
SD-424
SD-201
PoE Surge Protector
PoE Camera
IN=Input Patch Cables From The Field
Fail LED
OUT=Output Patch Cables To Equipment
Protected Equipment / PoE Switch
PoE Out
< 1 meter
SD-201
PoE Surge Protector
PoE Camera
PoE (Data + Power)
Remove
screws
Remove
screws
DEFAULTS
IP Address DHCP client
Thersttimeloginneedkeyinnewusernameandpassword,
please enter the new username and password, and then click the
<Apply> button.
LEDs
IP Module
LAN Greenash Data is being transmitted or received.
OFF No connection.
SYS Yellow ON: System is ready, Power is supplied.
Surge Module Fail Red ON: Out of service life.
Reset Button Reset to default 15 seconds
IN=Input Patch Cables From The Field
Fail LED
OUT=Output Patch Cables To Equipment
Protected Equipment / PoE Switch
#12awg.
Ground wire must be
as short as possible
Remove
screws
/