MONDOLUX MD29 Installation guide

Type
Installation guide
Product code mondolux.com.au
Cannes Maxi
DOWNLIGHT Product code MD29
Installation Manual
Notes
This tting requires 220-240V AC/50Hz power input to the driver.
Do not interchange any parts of this tting.
Allow a minimum distance between tting and illuminated subject of 800mm.
Do not touch tting when in use.
Do not install tting near any heat source.
Do not install any inductive loads such as exhaust fans etc. within the same lighting circuit of the
current tting. Issues caused by such connections will not be covered under our warranty policy.
If you have any questions about the installation of this product, please contact Mondolux.
Installation Steps
1. Ensure the mains power is turned o.
2. Drill required number of holes in the ceiling and x the mounting plate using the provided screws.
See picture 2.
3. Pass the power supply cable through the center of the mounting plate and secure it using the cable
grip provided. See picture 3.
4. Connect the L, N and E wires on the supply side to the respective terminals of the driver using
quick connectors. See picture 4.
5. Fit and rotate to x the tting to the mounting plate. See picture 3 and 4.
6. Installation is complete. See picture 5.
Picture 1 Picture 2 Picture 3
Picture 4 Picture 5 Picture 6
POWER OFF
POWER ON
CABLE GRIP
  • Page 1 1

MONDOLUX MD29 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI