CSM1000
Register your product and get support at
www.philips.com/welcome
EN User manual 3
ES Manual del usuario 13
PT-BR Manual do Usuário 25
RU Руководство пользователя 37
=+&1 Ⴌ߀൱Ҭ
49
3
English
EN
Contents
1 Important 4
Safety 4
Notice 4
2 Your car active subwoofer 5
Introduction 5
What’s in the box 5
Overview of the main unit 6
3 Installation 7
Mount the subwoofer in car 7
Connect wires 7
4 Use your active subwoofer 9
Adjust phase 9
Adjust frequency 9
Adjust volume 9
About the protector indicator 9
5 Product information 10
6 Troubleshooting 11
4
Any changes or modifications made to this
device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
2010 © Koninklijke Philips Electronics N.V. All
rights reserved.
Specifications are subject to change without
notice. Trademarks are the property of
Koninklijke Philips Electronics N.V. or their
respective owners. Philips reserves the right
to change products at any time without being
obliged to adjust earlier supplies accordingly.
1 Important
Safety
Read and understand all instructions •
before you use the apparatus. If damage
is caused by failure to follow instructions,
the warranty does not apply.
This unit is designed for negative ground •
(earth) 12 V DC operation only.
Use only the supplied mounting hardware •
for a safe and secure installation.
Do not connect any active speakers (with •
built-in amplifier) to the speaker terminals
of the unit. Doing so may damage the
active speakers.
To ensure safe driving, adjust the volume •
to a safe and comfortable level.
To avoid short circuit, do not expose the •
apparatus, remote control or remote
control batteries to rain or water.
Never expose the apparatus to direct •
sunlight, naked flames or heat.
Clean the apparatus with soft, damp •
cloth. Never use substances such as
alcohol, chemicals or household cleaners
on the apparatus.
Notice
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and
old equipment.
EN
5
g Tap type screw (M6x8 mm) x 4
h Washer x 4
i Machine screw (Ø5x20 mm) x 4
j Velcro straps x 2
k Cushion x 4
2 Your car active
subwoofer
Congratulations on your purchase, and
welcome to Philips! To fully benefit from the
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With the active subwoofer, you can enjoy high-
quality sound performance with powerful bass
and beats.
What’s in the box
Check and identify the contents of your package:
i
j
k
a Main unit
b Mounting plates x 2
c Power cable
d Power control cable
e Battery (+) cable
f Speaker wire
English
EN
6
Overview of the main unit
a PHASE
Adjust the phase of subwoofer signal.•
b FREQUENCY
Set LPF (low-pass-filter) frequency •
from 80Hz to 120Hz.
c VOLUME
Adjust volume from 0 to maximum •
level.
d INPUT (Ch1, Ch2)
To connect car audio with RCA cable.•
e POWER
Light in blue when power is turned •
on.
f PROTECTED
Lights in red when the protector is •
activated.
g POWER/HIGH LEVEL INPUT
To connect power supply (+12V-•
DC power supply, ground wire, and
remote control wire) and car audio
with bare wires.
a
b
c
e
f
g
d
EN
7
Connect wires
Caution
Ensure that all loose leads are insulated with •
electrical tape.
1 Connect the subwoofer to your car audio
by:
(option 1) connect to bare speaker •
wires from car audio.
(option 2) connect to the car audio •
directly via an RCA cable.
3 Installation
Note
Follow all mounting and wiring instructions. •
Mount the subwoofer in car
You can mount the subwoofer either under a
seat or on the rear tray.
Note
Make sure that the mounting location is safe •
for drilling and wiring, and it will not interfere
with the mechanical and electrical components
of the vehicle.
For under-seat installation, make sure that it
•
does not obstruct seat mobility.
1 Place the subwoofer on the location for
installation.
2 Mark the positions of the four screw
holes.
3 Drill the holes with driller of
approximately 4mm in diameter.
4 Mount the subwoofer with the supplied
screws and brackets.
English
EN
8
Tip
If your car audio does not have remote output, •
connect the remote input terminal (REM) to
the accessory power supply.
2 Make the power connection by:
connect the ground wire from the •
car to the GND socket.
connect the remote wire from the •
car audio to the REM socket.
With this connection, you can turn •
on/off the subwoofer with the car
audio.
connect the power wire from the car •
battery to the +12V socket
Car audio
Left speaker Right speaker
CSM1000
Option 1
Option 2
Car audio
Left speaker Right speaker
CSM1000
Option 1
Option 2
EN
9
About the protector
indicator
The subwoofer has a built-in protection circuit
to protect the transistors and speakers in
following conditions:
The subwoofer is overheated.•
A DC current is generated in the •
speakers.
The battery voltage is over low or •
over high. Or
The speaker terminals are short •
circuited.
When the PROTECTED indicator
lights up in red, the subwoofer shuts
down automatically. In this case,
please:
1 Take out the disc or tape and turn off the
car audio.
2 Check the cause of the malfunction.
3 If the subwoofer is overheated, let it cool
down.
4 Use your active
subwoofer
Note
Before playing music, position all knobs at the •
minimum level.
Adjust phase
The location of the subwoofer determines the
overall quality of the music. Even you are seat at
sweet spot, the bass effect you heard might not
in-phase with the overall music signal, for the
subwoofer created a phase difference. In this
case, you can change the phase of bass signal to
enhance overall bass response, as well as overall
feeling of the music.
1 Press down PHASE.
The bass signal is 180 degree out of »
phase with the original one.
To resume original bass effect, press •
PHASE again to release the button.
Adjust frequency
You can change LPF (low-pass-filter) frequency
from 80Hz to 120Hz.
1 Rotate FREQUENCY to adjust
frequency.
Adjust volume
You can change volume from minimum level (0)
to maximum level.
1 Rotate VOLUME.
English
EN
10
5 Product
information
Note
Product information is subject to change •
without prior notice.
Speaker type Active subwoofer
Maximum output power 550Watt
Rated power 85Watt
Operating frequency 80Hz ~ 120Hz
Phase 0°, 180°
S/N ratio
(rated power: 4ohms)
95dB
Sensitivity
(1% distortion)
100mV at RCA,
1.8V at speaker
level
Operating voltage 14.4V
(10.5V ~ 16V)
Dimensions (DxWxH) 240 x 350 x 80mm
Weight (main unit) 3.9 kg
EN
11
6 Troubleshooting
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
The sound is too low.
The volume is not set correctly (see •
“Adjust volume”).
The sound is interrupted or stopped suddenly.
The thermal protector is activated. •
Reduce the volume.
The ventilation outlet is blocked. Remove •
any obstructions from the outlet.
Alternate noise is heard.
The power connecting wires are installed •
too close to the RCA pin cords.
The ground wire is not securely •
connected to a metal point of the car.
Negative speaker wires touch the car •
chassis.
Sound is distorted.
Make sure the speaker polarity is correct. •
Adjust phase. •
The protector indicator lights up in red.
The subwoofer is overheated. Cool down •
the subwoofer.
The unit becomes abnormally hot.
Place the subwoofer in a well ventilated •
location.
English
EN
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
CSM1000_00_UM_V1.2
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
DLS CA51 Owner's manual
-
-
JBL GRAND TOURING GTR 102 Owner's manual
-
Hifonics BRE2500.1D User manual
-
PowerBass XMA-5900IR Owner's manual
-
-
DLS CLASSICAMPENG03 Owner's manual
-
Brutus Power Pro 1100 Owner's manual
-
Phoenix Gold Ti3 1200W 4 Channel Amplifier User manual
-
Crunch GTR Owner's manual
