Edelbrock 10021002 Operating instructions

Hello! I've reviewed the installation instructions for the Edelbrock Pro-Flo air filter. This document contains information about the installation process, maintenance tips, and some cautions regarding the installation. I'm ready to answer your questions about this product and the document content.
How often should the air filter be washed?

What should be done if the carburetor stud nut requires replacement?

What size is the neck and bridge of the air filter?

INSTALLATION INSTRUCTIONS

PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY AND

THOROUGHLY BEFORE INSTALLING YOU NEW AIR CLEANER

CATALOG #1002

MODEL: Pro-Flo Re-usable air filter with 5-1/8" neck and bridge

INSTALLATION INSTRUCTIONS: On air filters for most 4-bbl. carbs, the hold-down bracket supplied in this kit must be bent in the

center to fit snugly inside of the carb opening (see Figure 1). Bracket must be positioned to clear carburetor choke linkage. For carbure-

tors with tall bowl vent tubes, it may be necessary to purchase Edelbrock air cleaner spacer #8093. Vent tube to air cleaner clearance

should be no less than 1/8". CAUTION: Top of carburetor stud must be completely through nylon lock nut to prevent lock nut from com-

ing loose and cause damage to engine. If nut is removed from carburetor stud, it must be replaced with a new nut (see Figure 1).

MAINTENANCE: This exclusive urethane foam element retains its high filtering efficiency when washed at 2000 mile intervals.

Geographic location and/or vehicle usage may require more frequent cleaning. Simply remove filter by releasing one spring clip, then

wash in hot soapy water.Allow element to dry, then re-assemble. When needed, replacement filters (Edelbrock #1099) are available

through your dealer.