MHSC MJ27NR-S MJ27PR-S SIT Proflame Conversion Install Manual

  • Hello! I've reviewed the SIT Proflame Conversion Instructions for models MJ27NR-S and MJ27PR-S. This document provides step-by-step instructions for installing a remote receiver and setting up remote control operation of your appliance. I'm here to address your questions about the instructions, wiring, or synchronization process.
  • What should be done before starting the installation?
    What is the first step in the conversion process?
    What color wires should connect to the TP/TH and TH terminals on the valve?
    How do you confirm the synchronization of your device with remote?
KIT CONTENTS:
Remote ................................. 1 ............................ 20308625
Receiver ...............................1 ............................ 20308624
Wire Harness ........................1 ............................ 20308626
Note: Heat reduces battery life. You can protect the receiver
and extend the battery life by mounting the receiver in the
wall or other location outside the replace.
Conversion Instructions
1. Turn o Gas and electric to the appliance.
2. Disconnect the two (2) female connectors from the
TP/ TH and TH terminals on the control valve.
3. Disconnect the wire harness from the control valve.
This receiver may be discarded.
4. Set remote receiver. Refer to instructions included in
receiver kit.
5. Connect the 14-pin female connector from the wire
harness to the 14-pin male connector on the back of
the receiver.
6. Connect the two (2) 1/4" female connectors to the valve.
The white wire connects to the TP\ TH terminal and the
green wire connects to the TH terminal on the valve.
See Figure 1.
7. Connect the four-pin connector from the control valve to
the four-pin connector of the wire harness.
8. After the batteries have been installed in the remote
and receiver, move the three position slider switch to he
“Remote” position.
9. Use the end of a paper clip, or other similar object, to
push in the hole marked “PRG” on the receiver front
(you should hear three beeps for conrmation.
10. On the remote, push the ON button (you will hear four
beeps to conrm the synchronization of your device.)
11. For further instructions, refer to the instruction sheet
included with the SIT Proame remote.
FP2010
remote receiver
TP/TH TP TH
White
Green
Figure 1. Installing
Remote Receiver
Remote Receiver
Remote Wire
Connectors
Valve
Motor
Wires
WARNING!
Power to the appliance must be shut o before
attempting service or repairs.
Allow gas appliance to cool completely before
attempting to install or remove remote receiver.
Only a qualied service technician should perform
installation of the remote receiver.
20308668 01/18 Rev. A
SIT Proame Conversion Instructions
Models: MJ27NR-S, MJ27PR-S
Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 50044
www.monessenhearth.com
/