morse 201/10-1 Operators Manual and Parts Diagram

Type
Operators Manual and Parts Diagram
Copyright 2018 - Morse Mfg. Co., Inc. Form PL 1-5P (Updated July 27, 2018 4:00 PM) 1
The Specialist In Drum Handling Equipment
Model 1-5P
Idler Attachment
Morse part # 1-5P Idler Attachment
to roll a 1 to 5 gallon can on 201 series Portable Drum Roller
[email protected] 727 West Manlius St.
East Syracuse, NY, 13057 USA
morsedrum.com (315) 437-8475
Assembly Instructions
Fasten each roller base (item 1) onto the rotator 1.
channel as shown in diagram. Use the four bolts
(item 7) and four whiz-lock nuts (item 8) provided.
With the roller tube (item 2), collars (item 3), roller 2.
axle (item 4), tube bearing (item 5), and roller holder
(item 6) assembled as shown, slide both roller
holders (item 6) directly inside each roller base tube.
Tighten down both collars on roller holders (item 6).
Adjust large collars (item 3) on the roller tube (item 3.
2) far enough apart so that the can rolls between
them.
Adjust the drive wheels on the rotator to roll the can.4.
  • Page 1 1

morse 201/10-1 Operators Manual and Parts Diagram

Type
Operators Manual and Parts Diagram

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI