morse 1-5P Operators Manual and Parts Diagram

Hello! I'm a chat assistant and I've reviewed the assembly instructions for the Morse 1-5P Idler Attachment. This document includes step-by-step guidance for assembling the idler attachment to a 201 series portable drum roller. It also contains a parts list of the components needed. I'm ready to answer any questions you have about the device and the instructions.
What size cans is the 1-5P Idler Attachment designed for?

What other product is the 1-5P Idler Attachment compatible with?

How many bolts and nuts are used to fasten roller base?

The Specialist In Drum Handling Equipment

Model 1-5P

Idler Attachment

Morse part # 1-5P Idler Attachment

to roll a 1 to 5 gallon can on 201 series Portable Drum Roller

[email protected] 727 West Manlius St.

East Syracuse, NY, 13057 USA

morsedrum.com (315) 437-8475

Assembly Instructions

Fasten each roller base (item 1) onto the rotator 1.

channel as shown in diagram. Use the four bolts

(item 7) and four whiz-lock nuts (item 8) provided.

With the roller tube (item 2), collars (item 3), roller 2.

axle (item 4), tube bearing (item 5), and roller holder

(item 6) assembled as shown, slide both roller

holders (item 6) directly inside each roller base tube.

Tighten down both collars on roller holders (item 6).

Adjust large collars (item 3) on the roller tube (item 3.

2) far enough apart so that the can rolls between

them.

Adjust the drive wheels on the rotator to roll the can.4.