Instruction manual
9
8. NEVER ATTEMPT TO LIGHT A BURNER THAT DOES NOT HAVE A LIT BURNER DIRECTLY ADJACENT TO IT.
THIS COULD CAUSE A HAZARDOUS SITUATION TO OCCUR.
Warning: If any burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve
off. Wait five minutes before attempting to relight with ignition sequence.
After use, close the gas supply by either turning ‘OFF’ the switch on the regulator or turning ‘OFF’ the
cylinder valve.
In the event of light back whilst the appliance is in use. Turn all the controls, cylinder valve and regulator
switch to the ‘OFF’ position. Wait 5 minutes before attempting to relight the appliance. If the problem
persists after relighting, consult your gas dealer, or the store where you purchased the
barbecue/plancha
,
or a qualified gas engineer for assistance or repair. Never try to rectify the problem yourself as this could
result in serious injury and/or property damage.
STORAGE AND CLEANING
Rust spots may appear on the product due to the metallic particles contained in the stainless steel used
in the manufacture of this product. We recommend that you brush them off quickly to limit their spread.
After each firing, wait for the product to cool down completely.
Empty the grease trap and clean your appliance and utensils after each use to avoid a highly flammable
and toxic grease deposit on the cooking surfaces.
Do not use sharp objects or abrasive cleaners on the cooking surface. It is preferable to use a heavy-duty
degreaser.
Do not leave standing water in the appliance; this can lead to rust and rapid deterioration of the
materials.
Protect your appliance with a cover if you leave it outside in fine weather. Protect from rain and
moisture during extended periods of non-use.
Before use, check the hose for nicks, cracks and signs of severe wear. Make sure the expiry date has not
passed.
Carry out a leak test at the beginning of each season and each time you replace the cylinder to ensure
that the appliance and its connections are working properly.
NEVER USE AN OPEN FLAME TO DETECT GAS LEAKS. DO NOT LIGHT THE APPLIANCE DURING THE TEST.
Turn all appliance controls to OFF, Connect your gas cylinder correctly, Open the gas cylinder valve.
To detect a leak, brush a solution of equal parts liquid soap and water over all the gas connections
(valves, hose, regulator and hex nut).
If bubbles form anywhere, this indicates a leak.
GAS CYLINDER
The appliance can be used with any gas cylinder of weights between 4.5KGS and 15KGS butane and 3.9KGS
to 13KGS propane. The gas cylinder should not be dropped or handled roughly! If the appliance is not in