Judge JEA51 - 550W User manual

  • Hello! I have reviewed the instruction manual for the JUDGE Blender model JEA51. It covers everything from assembly and operation to cleaning and safety precautions. The blender has a 1.5L glass jug, pulse function, and two speed settings. I'm here to help with any questions you might have about the blender or its use, so please don't hesitate to ask!
  • What is the maximum temperature of liquids that can be processed?
    Can I add ingredients while the blender is operating?
    What should I do if the blender has been overfilled?
    What parts of the blender are dishwasher safe?
Blender with Glass Jug
Instruction
Manual
Blender
with
Glass Jug
Model No. JEA51 - 550W
UNPACK YOUR BLENDER CAREFULLY (CUTTER BLADES ARE SHARP!)
AND REMOVE PACKING PIECES, LABELS AND STICKERS BEFORE USE.
Please read this
instruction manual
carefully before use and
save for later reference.
Blender with Glass Jug
Identifying the parts
of your Judge Blender
1500 ml
1400
1300
1200
1100
1000
900
800
600
500
For Spare Parts please contact
Judge Customer Services -
for address see Guarantee Section.
Measuring Cup /
Pouring Hole Cover
(SPARE PART CODE: JEA51M)
Lid, with Pouring Hole
(SPARE PART CODE: JEA51L)
Glass Jug
(SPARE PART CODE: JEA51J)
Jug Handle
Sealing Gasket
Cutter Blade Assembly
(Take Care - Sharp Blades)
Jug Base
Revolving Spigot
Motor Body
Pulse Button
Operating Switch
0 = OFF
1 = Low Speed
2 = High Speed
Mains Lead and Plug
Blender with Glass Jug
Assembly
Use
2. The Lid is a push-fit into
the top of the Jug .
3. Lower the assembled Jug onto
the Motor Body . Turn clockwise
until the Jug locks into place.
NOTE: the appliance will not
operate until assembled correctly.
BEFORE FIRST USE: wash
assembled Jug and Lid in warm
soapy water, rinse and dry.
Ensure that the appliance is
disconnected from the electricity
supply before assembly.
1. The Measuring Cup pushes
into the Lid Pouring Hole - turn
the Measuring Cup clockwise
to positively lock into place.
The appliance should be sited on a
dry, level and stable surface,
away from direct heat.
1. With the appliance switched OFF
( Position 0) add ingredients to
the Jug by removing the lid .
2. When you have added your
ingredients to the Jug , push the
Lid securely back into position.
3. Stabilise the appliance by placing
one hand on top of the Lid
(with the Measuring Cup /
Pouring Hole Cover fitted)
4. For best results begin blending
by pressing the Pulse Button
two or three times, allowing the
ingredient pieces to drop to the
bottom of the Jug between bursts.
5. Food may then be further
blended by using the Operating
Switch in position 1 (low
speed) or 2 (high speed).
The Lid must always be
attached to the Jug while
the appliance is operating.
Ingredients may also be added
to the Jug while the appliance
is operating ( Position 1/2)
by removing the Pouring Hole
Cover from the Lid .
Removing processed food
Before removing food from the
Jug , wait until the Cutter Blades
have stopped spinning.
1. Disconnect the appliance
from the electricity supply.
2. Remove the Lid .
3. Pour food from the Jug
, scraping contents down with
a spatula if necessary.
To remove foods of a more solid
consistency, remove the Jug
from the Cutter Blade Assembly
(Take Care - Sharp Blades)
and Jug Base . Scrape food
from the Jug with a spatula.
Blender with Glass Jug
Self Clean Function
Once you have emptied the contents,
simply add 1L of water and a
small amount of liquid detergent
and follow the “Use” & “Removing
processed food” instructions.
Tips
Periodic Cleaning
Thoroughly wash the Jug , Lid
and Cutter Blade Assembly
using warm soapy water.
Detachable parts / / / /
/ are also dishwasher safe.
Motor Body is wipe clean only,
using a damp, soapy cloth.
Use a plastic spatula to scrape-down
any pieces of food that stick to the
inside of the Jug : Ensure the
machine is disconnected from mains
electricity supply before placing
utensils or fingers into the jug.
The maximum temperature of
liquid foods that can be processed
is 80°C. It is better to allow
soups, broths etc to cool to a
lower temperature if possible.
If processing hot liquids the
maximum capacity is reduced to 1L
At least one cup of liquid must
be added to Ice Cubes before
they will blend properly.
The Judge Blender is versatile
but it isn’t a replacement for
all other kitchen gadgets: it will
not mash potatoes, whisk egg
whites, chop raw meat, knead or
mix stiff doughs or extract juices
from fruit and vegetables.
Keep ingredient pieces roughly
the same size when possible, this
makes uniform blending easier.
Cubes approx. 2.5cm / 1” are ideal.
It is usually best to put liquid
ingredients into the Jug first.
The appliance can complete
a task in seconds - stop and
check the consistency every few
seconds rather than overblend.
Most chopping tasks are best
performed by using the pulse control.
Do not overload the motor with
extra heavy or extra large loads.
If the blender has been overfilled,
disconnect from mains electricity
supply and remove some of the
ingredients before continuing.
If you run the motor continuously for
3 minutes, wait at least 5 minutes
before running the motor again.
Storage
Reassemble the appliance and store
with Lid ajar in a safe place.
Blender with Glass Jug
Cautions
Before Use
Check that your mains power supply
corresponds to the voltage shown in this
manual (also shown on the rating plate,
located under the Motor Body ).
Do not connect the Plug into
your socket with wet hands.
Ensure that the Mains Lead is not near
any hot surface, and is not in a position on
the worktop where it could be ‘snagged’. The
Mains Lead should not hang over the side of the
worktop, where it could accidentally snagged
or pulled by children. There is a cord shortening
facility located under the Motor Body .
Do not move the appliance around
by pulling the Mains Lead .
Inspect the Jug to ensure it is free from
chips or cracks - these could cause the
Jug to break during use causing injury.
Always keep the appliance out
of the reach of children.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or
lack of experience or knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
This appliance is not intended to be
operated by means of an external timer
or a separate remote-control system.
The appliance should only be used as
instructed: there is potential
for injury from misuse.
Never mount the Cutter Blade Assembly
onto the Revolving Spigot
without the Jug attached.
Never leave the appliance unattended
while it is operating.
The Jug and Lid must be securely
locked in position before operating the
machine: do not attempt to defeat
the safety interlock mechanisms.
Do not use any other jug or parts other
than those supplied with the appliance.
In Use
Do not attempt to remove
the Jug or Lid while
the machine is working.
Do not operate the motor
when the Jug is empty.
After Use
Ensure the Cutter Blade
Assembly has come to a
complete stop before removing
the Lid from the Jug .
Always disconnect the electricity
supply before removing
the Jug from the Motor
Body , or approaching any
part that moves in use.
Do not use fingers to scrape
food away from the Cutter
Blade Assembly . A plastic
scraper may be used, but only
when the electricity supply
has been disconnected.
Care must be taken handling
the sharp blades when
assembling, emptying the Jug
and during cleaning.
Unplug the appliance
when not in use.
Pull the plug (not pull Mains Lead)
to disconnect from mains socket.
Do not immerse the Motor
Body in water.
Faults and damage
If the Jug is chipped or cracked
If the Mains Lead has
been damaged in any way.
If the Blender appears to be
faulty or damaged in any way
Do not switch on or attempt
to operate. Please contact
Judge Customer Services, for
address see Guarantee Section.
Never attempt to repair to
the appliance yourself
Please keep your purchase receipt.
Blender with Glass Jug
The Judge 2 Year Domestic
Electrical Guarantee covers the
product to be free of defects in
materials and workmanship for
a period of TWO YEARS from the
date of original retail purchase.
During this period, JUDGE will,
at their option, repair or replace
defective parts of the product,
or replace the product, providing
the Use Care and Safety
Advice have been followed.
The Guarantee does not cover
damage, defect or failure
caused by or resulting from
accidents, external damage,
alteration, modification, abuse,
misuse or misapplication.
The Guarantee does not
cover any damage caused by
taking the appliance apart
yourself, or attempting to
repair the appliance yourself.
THE PRODUCT IS INTENDED
FOR DOMESTIC USE ONLY.
Please keep your Purchase
Receipt and contact us
directly if you encounter any
problems with your product.
HORWOOD SHALL NOT BE
LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES
RESULTING FROM THE USE OF
THIS PRODUCT (INCLUDING
COLOUR FADING, SCRATCHES OR
ACCUMULATED DIRT) WITHOUT
FOLLOWING THE USE, CARE
& SAFETY INSTRUCTIONS.
Note: Due to the introduction
of improvements from time to
time, the right is reserved to
supply products which differ
slightly from those illustrated and
described in this publication.
Errors and Omissions Excepted.
CUSTOMER SERVICES
Horwood, Avonmouth Way,
Bristol, BS11 9HX, Great Britain
www.judgecookware.co.uk
Tel: 0117 940 0000
Specification
Name Model No. Capacity Rated Voltage Rated Frequency Rated Power
Judge Blender
with Glass Jug
JEA51 1.5L 220 - 240v 50Hz 550W
Judge 2 Year Domestic Electrical Guarantee
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your
used device, please use the return and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
FOR DOMESTIC USE ONLY
/