How-To Guide
Setup Guide for:
U-PROX Readers via U-Prox app
Page 1 of 3Rev 1.0
- Download U-
Prox Config & U
-
Short Data 0 (Green) & Data 1 (White) *Initial Setup Only*
- Power the reader
- Open U-
Prox Config and search for the reader (you will need to be close)
Initial Steps:
Prox Config & U
-Prox ID
from Apple App Store or Google Play
Short Data 0 (Green) & Data 1 (White) *Initial Setup Only*
Prox Config and search for the reader (you will need to be close)
from Apple App Store or Google Play
Prox Config and search for the reader (you will need to be close)
How-To Guide
Page 2 of 3
How-To Guide
Page 2 of 3
-
Select the reader once it is found and tap on the plug icon
Select the reader once it is found and tap on the plug icon
- Go to “SETTINGS”
Select the reader once it is found and tap on the plug icon
How-To Guide
Page 3 of 3
Innovative Electronic Solutions
www.ness.com.au
National Customer Service Centre
Ph: 1300 551 991
From
here you will be able to:
- Load
the profile that allows the reader to communicate with the U
App (Please note profile 1359 must appear behind serial number)
*Fol
low this
- Set an
Installer code so the reader can be accessed without shorting D0 & D1
- Se
t the reader format to the required setting for specific cards/tags
- Ad
just the Wiegand output as needed *Our guides are for Wiegand 26 bit*
- Once se
ttings have been changed,
screen and select “SAVE TO DEVICE”
From here you will be able to:
Load the profile that allows the reader to communicate with the U
App (Please note profile 1359 must appear behind serial number)
*Follow this
guide to load the profile if using U-Prox
ID*
an Installer code so the reader can be accessed without shorting D0 & D1
Set the reader format to the required setting for specific cards/tags
Adjust the Wiegand output as needed *Our guides are for Wiegand 26 bit*
Once settings have been changed, select “Back” to navigate to the previous
screen and select “SAVE TO DEVICE”
Load the profile that allows the reader to communicate with the U
-Prox ID
App (Please note profile 1359 must appear behind serial number)
Prox ID*
an Installer code so the reader can be accessed without shorting D0 & D1
Set the reader format to the required setting for specific cards/tags
Adjust the Wiegand output as needed *Our guides are for Wiegand 26 bit*
select “Back” to navigate to the previous
-
1
-
2
-
3
U-Prox U-Prox CLC Controller User guide
- Type
- User guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI