Naomi Kids Gourmet Kitchen Assebly Instructions

  • Hello! I am an AI chatbot trained to assist you with the Naomi Kids Gourmet Kitchen Assebly Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Gourmet Kitchen
WARNING
CAUTION
?ADULT ASSEMBLY REQUIRED.
?CHOKING HAZARD. This product includes small parts, sharp points and sharp
edges in its unassembled state. Keep unassembled parts away from children
under 3 years of age.
?If used improperly, your kitchen may be pulled over or fall, creating risk of injury
or damage. Children should not be permitted to climb or pull on the kitchen.
USE AND MAINTENANCE:
?Use on level surfaces only!
?Because this product needs assembly, it is prone to working itself loose from time
to time depending on the use. Please take the time to check that all connections
are still tight and working properly for the safety and enjoyment of your child.
PARENTAL SUPERVISION IS REQUIRED.
?This Naomi Kids product is intended for a specific age or older.
?Parents or Guardians should supervise the play area in case younger children
have access to it and might climb on it.
?See instructions included with the wall strap.
Page 01 of 20
PRN: AIM-27-3120w-NAI [13.09.23]
--- A Message from Naomi Kids ---
Dear Parents and Dealers,
Thank you for choosing the Naomi Kids kitchen for continued entertainment and enlightenment of your growing
child. At Naomi Kids we take great pride in our products, and as parents ourselves we recognize that safety and
quality are our highest priorities. As new safety regulations arise, Naomi Kids has taken every precaution to ensure
that our products remain compliant with changing laws and policies.
The Naomi Kids testing program ensures that the products meet or exceed all federal and CPSIA requirements,
including mechanical hazards, lead and other heavy metals, phthalate and flammability. All product testing is
performed by third-party certified labs to verify that they meet or exceed all applicable U.S. regulatory safety
standards.
Most recently, Naomi Kids reviewed and confirmed compliance with the Illinois Lead Poisoning Prevention Act,
which sets lead limits on any children's product being sold in the state.
The California Air Resources Board (CARB) ACTM 93120 requirement is a multi-step regulation that limits
formaldehyde emissions in composite wood products being sold into California. CARB is currently in Phase 2,
which is the last phase of the act, and Naomi Kids products remain compliant.
Naomi Kids is committed to you and the safety of your children while delivering high quality products that will last.
You can trust in Naomi Kids testing program to keep your growing child's mind and body safe from harm when you
select a Naomi Kids product.
Thank you for your continued support.
Sincerely,
Naomi Kids Product Safety Team
Page 02 of 20
30 x 5
1
2
3
4
5
6
7
8
10 x2
11
13
13
9
9
14
15
16
17
18
19
20
21
22
23
31
32
33
34
35
24
25
12
36
37
38
27 x 2
28
29
26 x 2
25 25
25
Page 03 of 20
This drawing is to give you an overall idea only of how this assembly will go together and does
not replace the assembly instructions.
Please take a moment to read through the whole instruction booklet before assembly to familiarize
yourself with this product. Once you feel ready to start, follow the instructions step by step and this should
make this process as easy as we could make it for you.
Due to the number of parts involved,
assembly can take a few hours
so set aside between 2 and
3 hours to assemble this
without rushing.
ASSEMBLY AT A GLANCE
Page 04 of 20
COMPONENT PARTS
1
3
25
26
27
2
Right Panel (x1)
4
Middle Panel 1 (x1)
19
Faucet (x1)
30
Door Handles (x5)
21
Counter Top (x1)
20
Burners (x4)
22
Backsplash
behind Sink (x1)
23
Backsplash
behind Stove (x1)
8
Bottom Left
Panel (x1)
Bottom Panel (x1)
5
Middle Panel 2 (x1)
6
Dishwasher Control
Panel (x1)
9
10
11
Fridge Shelves (x2)
Towel
Rack Supports (x2)
Towel Rack (x1)
12
Towel Knob (x1)
13
14
Backwall behind
Dishwasher and
Oven (x2)
Toe Kick (x1)
Microwave Right
Support (x1)
16
Microwave Left
Support (x1)
17
Microwave
Bottom (x1)
18
Shelf (x1)
Top Valance (x1)
31
Microwave
Door (x1)
32
Top Fridge Door (x1)
33
Fridge Door (x1)
34
Dishwasher
Door (x1)
35
Oven
Door (x1)
24
Microwave
Control Panel (x1)
Wood Gliders (x4)
Dishwasher Rack
Front/Back (x2)
Dishwasher
Rack Sides (x2)
28
Dishwasher Rack (x1)
38
Backwall Fridge (x1)
36
Top Panel (x1)
37
Sink (x1)
7
Stove Control
Panel (x1)
29
Stove Rack (x1)
15
For ease of identification,
Components have been
marked with a removable
sticker showing their
assigned number in these
instructions.
Page 05 of 20
ASSEMBLY HARDWARE
Identify arrow
on head.
Look closely.
1
Note : Use a Phillips Screw-Driver for assembly (not included).
Please check to see if you have all the parts and components listed here. If you are missing any
parts please STOP and contact customer service. Visit www.Naomihome.com
M4 x 45mm Phillips Cone Screw (x43) M3 x 13mm Phillips Cone Screw (x20)
Cam Lock (x4)
Hinge (x10)
A D
I
G
M3 x 20mm Phillips Cone Screw (x22)
M5 x 25mm Wood Guide Pin (x38)
Male Lock (x5)
Cam Stud (x4)
M4 x 20mm (x22)Phillips Cone Screw
M3 x 9mm (x40)Phillips Flat Screw
Female Lock (x5)
C
F
K
H
B
E
J
INSTALLING CAM LOCKS
ARROW
2Arrow MUST point toward
hole in edge of panel.
3Push cam lock all the
way down into hole.
INSTALLING CAM BOLTS
H
WALL STRAP BRACKET KIT
For details on this kit, please
go to page 19 for more info.
PRE-ASSEMBLY PREP - HARDWARE ASSEMBLY
Page 06 of 20
21
57
10 x2
3
24
17
18
8
16
15
F
F
F
F
FF
F
F
F
F
F
F
F
F
F
F
F
14
F
F
F
F
I
I
21
H
H
H
H
H
PRE-ASSEMBLY PREP - HARDWARE ASSEMBLY
Page 07 of 20
36
4
6
6
D
J
J
J
D
I
ID
J
J
D
TURN OVER
x5
D
D
Stove side
Dishwasher side
J
D
PRE-ASSEMBLY PREP - HARDWARE ASSEMBLY
Page 08 of 20
32
30
31
30
D
K
B
EG
B
34
33
G
E
E
34
35
30
35
D
K
G
E
G
E
E
G
30
30
30
33
D
DKB
B
B
B
Hinge Attachment
to Door (x10)
Male Lock Attachment
to Door (x5)
Handle Attachment
(x5)
21
Top view
28
26
26
27
27
27
27
26
26
C
CC
C
C
C
C
C
20
CC
CC
C
A
A
A
A
F
F
A
A
A
20
20
20
20
20
20
20
Please Note: Double check to make
sure all the burners line up the same
way.
Page 09 of 20
PRE-ASSEMBLY PREP - HARDWARE ASSEMBLY
2
1
34
2
3
2
3
FA
1
2
3
1
2
A
2
4
A
A
4
5
4
F
F
5
Page 10 of 20
ASSEMBLY INSTRUCTIONS
5
7
6
2
6
6
6
7
F
8
2
A
A
7
8
7
5
8
2
7
3
5
6
F
A
Page 11 of 20
F
ASSEMBLY INSTRUCTIONS
9
8
Please note: After Step 8 is completed, please carefully lift up the unit from the top end so that it
stands upright for Step 9. Make sure the area is clear so the unit stands flatly on the floor. Then
proceed to Step 9.
10
8
A
8
10
11
12
8
A
1
9
9
4
A
A
A
View of opposite angle
1
49
9
A
A
A
A
A
A
F
F
Page 12 of 20
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
11
10
8
6
4
13
13
Screw panel 15 into panel 17 first. Add Shelf 18
next and then attach Panel 16.
16
15
17
18
F
A
A
F
Page 13 of 20
21
8
6
12
13
6
21
21
21
19
15
16
A
A
A
A
C
C
15
16 21
Top view
C
A
A
19
H
H
HH
II
I
I
8
I
8
H
4
14
4
14
F
Inside view
CAM LOCKING
Page 14 of 20
ASSEMBLY INSTRUCTIONS
14
15
4
21
4
21 A
Inside view
15
F
14
A
F
22
23
16
15
4
F
24
Page 15 of 20
Place the wood dowels into the holes in
the microwave side before installing the
bolts in the step below.
ASSEMBLY INSTRUCTIONS
16
36
38
1
38
36
1
C
17
36
16
A
F
F
36
16
15
24
4
1
C
Page 16 of 20
ASSEMBLY INSTRUCTIONS
19
28
29 26
27
26
25
25
25
25
4
6
8
25
4
B
B
18
Page 17 of 20
ASSEMBLY INSTRUCTIONS
32
33
34
35
1
6
8
16
31
ASSEMBLY INSTRUCTIONS
20
37
21
21
33
1
E
G
E
Hinge Attachment (x10)
Page 18 of 20
Page 19 of 20
WALL STRAP BRACKET KIT
For safe use of this kitchen we recommend that you secure it to the wall with the wall strap bracket kit included.
To secure it to the wall, it is best to screw it into a wood stud but if that can't line up with the hole for the bracket on
the back wall of the fridge/freezer, use the plastic wall anchor provided. It is important to drill a hole for the wall
anchor the same size so that it sits in the hole snuggly. Use a 3/8 inch (3mm) drill bit and tap the anchor into the
hole. A loose anchor will not hold the bracket securely.
Please note: If anchoring into plaster, brick or other harder surfaces, you may wish to consult with your local
hardware store for the appropriate anchor and type of drill bit.
ASSEMBLY INSTRUCTIONS
ASSEMBLY HARDWARE
M2 x 30mm Phillips Flat Screw (x1)
12mm Washer (x2) 8mm Wrench (x1)
203mm Plastic Strip (x1)
8mm Lock Nut (x1)
3 x 30mm Plastic Anchor (x1) M4 x 20mm Phillips Bolt (x1)
A
E G
H
F
B C
20mm Washer (x1)
D
G
F
D
H
E
C
B
H
E
A
3mm (1/8") hole in wall
TO ATTACH TO THE BACK OF THE KITCHEN TO ATTACH TO THE WALL
Inside view
Drill Required for wall
anchor hole (not included).
Product Packaging Information
www.NaomiHome.com
MADE IN CHINA
COMPLETED GOURMET KITCHEN
Shipment info sticker goes here.
Page 20 of 20
/