JL Audio SB-F-TRKCTR3/10W3 User manual

Brand: JL Audio

Model: SB-F-TRKCTR3/10W3

Category: Car speakers

Type: User manual

This manual is also suitable for

SB-F-TRKCTR3/10W3v3

JL Audio SB-F-TRKCTR3/10W3 is a stealthbox subwoofer enclosure designed for 2001-Up Standard Cab, Super-Cab, and Super-Crew trucks, including Harley Davidson and King Ranch trucks. It features an acoustic suspension (sealed) design and houses a single JL Audio 10W3-D6 subwoofer with a nominal impedance of 3 ohms and a continuous power handling of 250 Watts. The enclosure is recommended to be paired with a high-quality amplifier, such as the JL Audio 250/1, and can be tuned using the recommended crossover, infrasonic filter, and equalizer settings provided in the manual.

➔

Stealthbox

INSTALLATION GUIDE

for the

SB-F-TRKCTR3/10W3

(Fits 2001-Up Standard Cab, Super-Cab

and Super-Crew trucks

lso fits, 2001 Harley Davidson and King

Ranck trucks)

This Stealthbox is a product

which requires professional

installation skills and tools.

Please read this installation guide

thoroughly before beginning the

project. It will guide you step by

step through the installation.Several

of the steps in this process may

require two people to accomplish.

It is absolutely vital that the

enclosure be properly mounted to

the vehicle according to these

instructions. Failure to mount the

enclosure properly presents two

problems: 1) The sub-bass

performance will suffer due to the

movement of the enclosure caused

by the force exerted by the

woofer(s) and 2) A loose enclosure

presents a serious safety hazard in

the event of a collision or sudden

deceleration.

Please enjoy your JL Audio

Stealthbox responsibly.

STEP 1:

Remove the front cup holder to

reveal two 18mm bolts. Remove these bolts.

STEP 2:

Remove tray and liner to reveal two

18mm bolts. Remove these bolts. Remove

console from truck.

STEP 3:

Cut and remove the carpet under

the console as shown in the picture.

**WARNING**

Seat Belt sensor wire runs underneath this

carpet. DONOTCUTTHIS WIRE!

STEP 4:

Remove (unsnap) the rear panel of

the console.

STEP 5:

Remove the armrest lid of the

console by removing four Phillips head screws.

STEP 6:

Remove the 7mm bolt that is

exposed when console top is removed.

STEP 7:

Remove three 7mm bolts denoted

by the arrows in the picture.

START

HERE

Continued on Page 2 ➔

➔

➔➔

➔➔➔

➔

STEP 8:

Remove the four screws (two per

side) from the sides of the console.

STEP 13:

Reinstall the outside console over

the inner console and the Stealthbox with

eight 7mm bolts which were removed in

steps 6,7 and 8. Place the conlose/Stealthbox

back into the truck.

Cont.

From

age 1

Continued on Page 3 ➔

➔

STEP 9:

A large section of the bottom of the

console must be removed. The cut travels

from side to side 3/4”in front of the bolt at

the rear the bottom of the console (point

#1). This cut then angles down to meet the

edge of the bottom rib on the side of the

enclosure (point #2). The cut travels to the

other end of the rib(point #3) and then

angles up the side and across the bottom so

as to meet a point 1/2”inside the bolt at the

front of the bottom of the console (point

#4). The same path is taken on the other side

of the console.

STEP 14:

Run speaker wire so that it is

accessible at the front of the enclosure,

connect it to the enclosure and test for

proper operation.

➔

STEP 15:

Using an an 18mm socket wrench,

secure the front of the console to the vehicle

with the 18mm bolts removed in Step 1.

STEP 16:

Using an an 18mm open end

wrench, secure the rear of the console to

the vehicle with the 18mm bolts removed in

Step 4.

STEP 17:

Snap rear panel (removed in step

4) back unto rear of console.

STEP 18:

Reinstall cup holders (removed in

Step1).

STEP 10:

Remove the nine remaining 7mm

bolts to separate the inner console.

STEP 11:

Sandwich the Stealthbox between

the two halves of the inner console and

secure using the nine 7mm bolts removed in

step 10.

STEP 12:

Glue the two supplied 8”x8”pieces

of carpet to the sides of the inner console

(one per side).

➔

Bottom Rib

Specifications:

Enclosure Type: Acoustic Suspension (Sealed)

Driver Type: One JL AUDIO 10W3-D6 Subwoofer

Nominal Impedance: 3Ω

Cont. Power Handling: 250 Watts

JLAudio recommends using a high quality amplifier such as the JLAudio 250/1. The diagram below shows the recommended

crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power the the F-150 Stealthbox®.

Included Hardware:

(1) Replacement Tray

(2) 8”x8” Carpet Pieces

10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111

+12VDC Remote Preamp Output SectionGround

JL AUDIO 250/1

monoblock subwoofer amplifier

Left Ch. Right Ch. Left Ch. Right Ch.

Full-Range/Low-Pass/High-Pass

Output Mode

Amp LP Filter

120

200

Filter Freq. (Hz)

Mode/Slope

Off/12dB/24dB

Bass Control

+10

+13

+15

LF Boost (dB)

Infrasonic Filter

Off/30Hz

Amplifier Input Section

Input Voltage Input Sens.

Low/High

Signal Sensing

Off/On

Subwoofer Output

MONO OUTPUT ONLY

The JLAudio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information

about installing and tuning this amplifier.

➔

STEP 19:

Reinstall console top (removed in

Step 5) and place supplied tray into console.

Cont.

From

Page 2

➔

Mid/High Frequency Driver Information:

CONGRATULATIONS!

INSTALL COMPLETE.

XR570-CSi

XR570-CXi

Front Location Driver Size:

5"x7” (1271mm x 177.8mm)

Applicable JL Audio Products:

TR570-CXi, XR570-CXi or CSi

Rear Location Driver Size:

5"x7” (1271mm x 177.8mm)

Applicable JL Audio Products:

TR570-CXi, XR570-CXi or CSi

Estimated Installation Duration:

JL Audio SB-F-TRKCTR3/10W3 User manual

Brand: JL Audio

Model: SB-F-TRKCTR3/10W3

Category: Car speakers

Type: User manual

This manual is also suitable for

SB-F-TRKCTR3/10W3v3

Download PDF

report

JL Audio SB-F-TRKCTR3/10W3 User manual

This manual is also suitable for

JL Audio SB-F-TRKCTR3/10W3 User manual

Related papers

Other documents