Lithonia Lighting DSA Installation guide

HDWB – Heavy-duty wall bracket

•

12 guage plated steel for

industrical strength and extended

life.

• (8) – 7/16” wall mounting holes

for superior support

INSTALLATION INSTRUCTIONS

1. Remove original wall brackets and save for possible future use. Thread

original 1/2"-13 x 6" cap screw through one heavy duty wall bracket. Run

cap screw through arms making sure to capture metal spacer separating the

two wall arms. Mount other heavy duty wall bracket and secure with 1/2"-13

stop nut.

2. Secure bracket end of braces with 1/2"-13 x 5/8" cap screws and stop nuts.

3. Secure arm end of braces with 3/8"-16 x 5" cap screw and stop nut.

4. Adjust tension of all stop nuts to achieve desired stiffness of dock lights swing.

5. Refer to drawing below for parts location and identification.

DISCONTINUED