Astria Fireplaces DRL65 Instruction Sheet

Type
Instruction Sheet
GENERAL INFORMATION
FFGC - FLEXIBLE GASLINE
CONNECTOR KIT
This flexible gasline connector kit is designed to aid in attaching gas
fireplaces to the gas supply. This kit can only be used where local codes
permit.
The components in this kit are rated for both natural and liquified pe-
troleum gases.
See Figure 1, below, for a description of the components provided in
the kit. The kit also contains these instructions.
INSTALLATION INSTRUCTIONS FOR FLEXIBLE GASLINE CONNECTOR KIT
(CATALOG NO. 93L32, MODEL NO. FFGC) FOR USE WITH IHP GAS FIREPLACES
Step 1. Shut off the gas and the electrical power supply to the fireplace
before proceeding.
Make leak-free connections as detailed below -
Step 2. Attach the 3/8” NPT end of the fitting provided in the kit to the
fireplace gas valve.
Step 3. Attach the flexible connector to the 3/8” flare end of this fitting.
Step 4. Route the flexible connector carefully around any obstructions
in the control compartment towards the roughed-in gas supply
line.
Step 5. Finish bringing the gas supply line to within reach of the flexible
gas connector and attach the shutoff valve to the gas supply
line and then the flexible gas connector to it.
Step 6. Proceed with the fireplace installation as detailed in the instal-
lation and operation manual provided with it.
INSTALLATION INSTRUCTIONS
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Printed in U.S.A. © 2001 Innovative Hearth Products
P/N 750070M REV. A 11/2015
IHP reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor
for fireplace code information.
Figure 1
10/29/2015
HEARTH PRODUCTS
KITS AND ACCESSORIES
P/N 750070M, Rev. A
11/2015
WARNING:
THIS KIT MUST BE INSTALLED BY A QUALIFIED SERVICE
TECHNICIAN OR OTHER QUALIFIED AGENCY ACCORDING
TO THE MANUFACTURER’S INSTRUCTIONS, ALL CODES
AND REQUIREMENTS OF THE AUTHORITY HAVING JURIS-
DICTION IN THE USA OR CANADA. THE QUALIFIED AGENCY
PERFORMING THIS WORK ASSUMES RESPONSIBILITY FOR
THIS INSTALLATION.
CAUTION:
SOME SOAPS USED FOR LEAK DETECTION ARE CORROSIVE
TO CERTAIN METALS. CAREFULLY RINSE PIPING THOR-
OUGHLY AFTER LEAK TEST HAS BEEN COMPLETED. DO NOT
USE MATCHES, CANDLES, FLAME OR OTHER SOURCES OF
IGNITION TO CHECK FOR GAS LEAKS.
CAUTION:
TO AVOID PIPE COMPOUNDS FROM ENTERING THE SYSTEM,
APPLY COMPOUNDS ONLY TO MALE PIPE THREADS. DO NOT
APPLY COMPOUNDS TO THE FIRST TWO THREADS.
IMPORTANT:
COMPOUNDS USED ON THREADED JOINTS OF GAS PIP-
ING MUST BE RESISTANT TO THE ACTIONS OF LIQUIFIED
PETROLEUM GASES
KIT PARTS
Fitting
(3/8” Flare x 3/8” NPT)
Flexible Connector - 12” Length
(3/8” Flare x 3/8” Flare)
Shutoff Valve
(1/2” NPT x 3/8” Flare)
Innovative Hearth Products
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
  • Page 1 1

Astria Fireplaces DRL65 Instruction Sheet

Type
Instruction Sheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI