120 ml
360 ml
180 ml
300 ml
240 ml
Place Mug,
Select
Brew Size
129
11
10 31 2
Enjoy!
A. Set-Up B. Brew
Place a mug on the drip
tray. Lift the handle.
Select a K-Cup
®
pack. DO NOT remove or
pierce the foil lid.
Place the K-Cup
®
pack in the K-Cup
®
pack holder then lower the handle all the
way down to puncture the K-Cup
®
pack.
Please be careful to avoid the sharp needles
in the K-Cup
®
pack assembly housing.
Select the appropriate brew
size: 120 ml, 180 ml, 240 ml,
300 ml and 360 ml. Press the
flashing BREW Button.
A. To mount the filter to your brewer, simply loosen
the two screws, hang the filter and tighten the two
mounting screws (be careful not to over tighten).
B. To mount the filter to a nearby wall, please follow
the filter’s User Instructions.
Remove adhesive tape and
LCD screen protection label.
Extend the power cord
and plug the brewer into
the mains socket.
WARNING: Your plumbed K150P brewing system requires the
use of an external water filter. Valid options include an
external filter mounted to the rear surface of the brewer (3A)
or an external filter mounted to a nearby wall (3B).
www.keurig.co.uk
P/N 60-202665-001 Rev B
8/14
SET-UP GUIDE
Keurig
®
K-Cup
®
K150P Brewer
CAUTION: The K150P brewer is designed to handle local water pressures from 276 kPa up
to 8.6 bar. Consult a qualified plumber for water pressures in your area. Use plumbing fittings
and tubing specified to withstand 861 kPa.
Please consult the Owner’s Manual for more information on your brewer.
If you need further assistance please contact your Keurig Master
Distributor.
6 7 84
5
4
Ready
Choose Your
K-Cup
®
Pack &
Lift Handle
WATER
LEVE L
Español Français
Lift and lower the handle. DO NOT insert a
K-Cup
®
pack. Select a brew size then press
the flashing BREW Button to start a cleansing
brew. Hot water will flow into your mug.
Once finished, pour the hot
water into the sink.
Wait until the screen indicates
“READY” (~4 minutes).
Once the external filter is mounted to
either the brewer or wall, connect the
filter to the Inlet Plumbing Port by using
a 3/4 BSP Tap Adapter and turn on the
water supply.
Press and release the
power switch.
www.keurig.co.uk
DO NOT lift the handle while heating
or brewing.
Remove used K-Cup
®
pack after brewing.
CAUTION: K-Cup
®
pack will be hot.
NOTE: If your brewer has been exposed to
temperatures below freezing, we recommend you
allow two hours for an unpacked brewer to warm
to room temperature before powering on.
DO NOT remove or puncture the foil lid of the
K-Cup
®
pack.
-
1
-
2
