Operation Manual – ACSEI
H3C S9500 Series Routing Switches Chapter 1 ACSEI Configuration
1-2
z ID assignment. The ACSEI server assigns IDs to ACSEI clients to distinguish
between them.
z Mutual monitoring and awareness between an ACSEI client and the ACSEI
server.
z Information interaction between the ACSEI server and ACSEI clients, including
clock synchronization.
z Control of the ACSEI clients on the ACSEI server. For example, you can close
ACSEI client, or restart ACSEI client on the ACSEI server.
An ACSEI server can register multiple ACSEI clients. The maximum number of ACSEI
clients that an ACSEI server allows to register varies with devices.
1.1.2 ACSEI Timers
An ACSEI server uses two timers, the clock synchronization timer and the monitoring
timer.
z The clock synchronization timer is used to periodically trigger the ACSEI server to
send clock synchronization advertisements to ACSEI clients. You can set this
timer through command lines.
z The monitoring timer is used to periodically trigger the ACSEI server to send
monitoring requests to ACSEI clients. You can set this timer through command
lines.
An ACSEI client starts two timers, the registration timer and the monitoring timer.
z The registration timer is used to periodically trigger the ACSEI client to multicast
registration requests (with the multicast MAC address being 010F-E200-0021).
You cannot set this timer.
z The monitoring timer is used to periodically trigger the ACSEI client to send
monitoring requests to the ACSEI server. You cannot set this timer.
1.1.3 ACSEI Startup and Running
ACSEI starts up and runs in the following procedures:
1) Run the ACSEI client application to enable ACSEI client.
2) Start up the device and enable the ACSEI server function on it.
3) The ACSEI client multicasts registration requests.
4) After the ACSEI server receives a valid registration request, it negotiates
parameters with the ACSEI client and establishes connection with the client if the
negotiation succeeds.
5) The ACSEI server and the ACSEI client mutually monitor the connection.
6) If detecting the disconnection of the ACSEI client, the ACFP server will remove the
configuration and policies associated with the client.