Blaupunkt DX-R52 Owner's manual

Brand: Blaupunkt

Model: DX-R52

Category: Car media receivers

Type: Owner's manual

This manual is also suitable for

TravelPilot Navigation Radio/CD

TravelPilot DX-R52 / DX-R5

Installation instructions

http://www.blaupunkt.com

256

Installation instructions

Safety instructions

When carrying out installation work

and making connections please obser-

ve the following safety instructions:

-Disconnect the negative terminal of the

battery! When doing so, please ob-

serve the vehicle manufacturer’s safety

instructions.

-Make sure you do not damage vehicle

components when drilling any holes.

-The cross sections of the positive and

negative cables must not be less than

1.5 mm2.

-Incorrect installation may cause inter-

ference with electronic vehicle systems

or your car radio.

-Do not connect the vehicle’s plug con-

nectors to the radio!

-You can obtain the adapter cable re-

quired for your vehicle type from any

BLAUPUNKT dealer.

-Depending on the model, your vehicle

may differ from the description provid-

ed here. We accept no responsibility

for any damages due to incorrect in-

stallation or connection or for any con-

sequential damages.

If the information provided here is not

suitable for your specific installation re-

quirements, please contact your Blau-

punkt dealer, your vehicle manufactur-

er or our telephone hotline.

–The TravelPilot can be used in vehi-

cles with:

•10,5-14,4 V battery power

•Negative pole on the chassisInfor

mation on proper functioning

To ensure that the TravelPilot functions

properly, it is essential that the system

be calibrated after it has been complete-

ly installed (see Operating instructions

/ Contents / Calibration).

The system determines the distance trav-

elled via its connection to the vehicle speed-

ometer signal. If there is no speedometer

signal, it will be necessary to have a route

sensor mounted by an authorised custom-

er service centre.

In this case you will have to order a sen-

sor kit (route sensor, magnet strip,

bracket and plug) from your dealer.

Order-No.: 7 607 611 093

1. Power supply

1.1 Connection to the vehicle ISO

standard plug

To prevent electrical malfunctions in

vehicle ISO plugs, you have to use the

universal ISO adapter cable (Order-

No. 7 607 621 126) (see Fig. 1).

The following vehicles with ISO

standard connections can current-

ly be fitted with the universal ISO

adapter cable: Alfa Romeo, Citroen,

Fiat, Honda, Lancia, Mercedes, Peu-

geot, Porsche, Renault, Skoda.

For other vehicles with vehicle ISO

plugs, use the vehicle-specific ISO

adapter cables, e.g. for Audi, Skoda,

VW with active antennas (Order-No.

7 607 621 129) (see Fig. 2).

1.2 Power connection to vehicle-

specific plugs

If the radio connection in your vehicle

was fitted with a 10A fuse at the facto-

ry (see operating instructions or the

fuse box in your car.), you will still need

the vehicle-specific adapter cable

(see Fig. 3).

257

ESPAÑOL

PORTUGUÊS

ENGLISH

2. Connecting the speakers

2.1 Connecting the speakers to the

ISO standard plug

In vehicles pre-equipped with pas-

sive speakers (with 4-ohm speakers)

you can adapt the ISO plug in the

vehicle. If necessary, the ISO cable

(Order-No.7 607 647 093) can bd¯]sed

for extra length (see Fig. 4). Order spe-

cial adapter cables from your dealer

for vehicles pre-equipped with active

speakers.

3. Installing the antenna

Connect the antenna wiring to the en-

closed bracket (see Fig. 5).

3.1 Radio antenna

In pre-equipped vehicles (e.g.: VW,

Seat, Audi), the antenna gets its pow-

er supply via the antenna wire (see the

vehicle operating instructions). If you

want to replace the OEM radio with a

conventional radio, you will have to

order an antenna supply diplexer (Or-

der-No. 7 691 290 202) or the adapter

cable (Order-No. 7 607 621 129) from

your dealer. You will find information

on the installation and connection of

the antenna in the antenna installation

instructions. (see Fig. 5).

3.2 GPS antenna (satellite navigation)

You will find information on how to in-

stall the antenna in the enclosed an-

tenna installation instructions.

If the GPS antenna is installed inside

the vehicle, we cannot guarantee that

the system will function correctly.

4. Installing the TravelPilot

4.1 Setting the Gyro

Important: Before the TravelPilot is

inserted, the gyroscope must be put in

a horizontal position (see Fig. 8).

Important: Installation position of the

TravelPilot: right / left: min. -5˚/ max.

+5˚, front to back: min. -10˚ / max. +30˚

The TravelPilot is installed in the

standard car radio compartment pro-

vided by the manufacturer (see Fig. 6 ).

For vehicles without a DIN compart-

ment, Blaupunkt offers vehicle-specif-

ic installation kits for 50/52 mm units

for the most popular vehicle models.

Please check the installation condi-

tions in your vehicle and use a vehi-

cle-specific installation kit if necessary.

4.2 Installing the bracket

The bracket included with this Travel-

Pilot allows you to install the system in

vehicles with a DIN car radio compart-

ment measuring 182 x 53 x165 mm

and an instrument panel which is 1 to

20 mm in the area where the fastener

tabs are located, (see Fig. 6). For the

installation, you have to push the

bracket into the compartment and de-

termine which fastener tabs you can

bend over with a screwdriver (see

Fig. 6a).

Note: Bend over as many of the fas-

tener tabs as possible.

4.3 Installing the TravelPilot

Push all of the plugs into the sockets

until they lock into place. Now insert

the navigation system from the front

into the bracket. Apply gentle pressure

to both side edges and push it in until

the spring locks snap into position on

the right and left (you will hear a loud

click).

Important! When you push in the sys-

tem, make sure that you do not put any

pressure on the display, the knobs or

the keys!

258

4.4 Removing the TravelPilot

Insert the handles into the correspond-

ing holes on the left and right side of

the front panel and push them in until

you hear a loud click (unlocking the

side spring locks). Use both handles

to carefully pull the TravelPilot out of

the compartment. Now you can pull

out the connection cables by applying

pressure on the side of the plug (see

Fig. 7).

Note: Once the handles have locked

into place, they cannot be removed

until you pull the TravelPilot out of the

compartment.

4.5 Connecting the back-up light

signal wire

The back-up light signal wire connects

the system to the vehicle back-up light.

Make sure that this connection is

charged with 12 volts when the vehi-

cle is reversing.

Important: We assume no liability for

faulty connections and their conse-

quences!

4.6 Connecting the speedometer

signal

Important: Only an authorised cus-

tomer service centre should make this

connection.

The speedometer signal wire connects

the system to the vehicle-specific

speedometer signal connection.

Important: We assume no liability for

faulty connections and their conse-

quences!

5. Connection diagrams

Power connection to the

vehicle ISO standard plug .........Fig. 1/2

Power connection to

the vehicle-specific plug ............Fig. 3

Speaker connection

4 speakers (4 Ω/35 W) ..............Fig. 4

Antenna connection...................Fig. 5

TravelPilot installation ...............Fig. 6/6a

TravelPilot removal....................Fig. 7

Setting the gyroscope................Fig. 8

Connection assignments ...........Fig. 9

Connecting the sensors.............Fig. 10

259

ESPAÑOL

PORTUGUÊS

ENGLISH

7 607 621 126

Fig. 1 * Tel.-Mute (activ Low)

RRRF LF LR

4 Ohm

Fig. 4

Fig. 3

7 607 621 129

Fig. 2

Fig. 5

GPS antenna

Radio antenna

260

Fig. 8

+30°

–10°

90°

Fig. 7

O.K.

+30°

–10°

90°

Fig. 6

Fig. 6a

+30°

–10°

3. 3.

261

ESPAÑOL

PORTUGUÊS

ENGLISH

14710 13 16 19

36912 15 18

258

11 14 17 20

C-1 C-2 C-3

1Gala/Tacho 1 Speaker out RR+

2Tel.-Mute (active low) 2 Speaker out RR-

3 RFLS 3 Speaker out RF+

4Permanent +12V 4 Speaker out RF-

5Aut. antenna 5 Speaker out LF+

6 Illumination 6 Speaker out LF-

7 Ignition 7 Speaker out LR+

8Ground 8 Speaker out LR-

1—

2—

3—

4—

5—

6—

7 Sensor

8—

9 Sensor

10 —

Wheel sensor

CD-ChangerRC 10 Fig. 9

AmplifierEqualizer

C1 C2 C3

1Line Out LR 7

Telefon / Navi NF in + 13 CDC Data-IN

2Line Out RR 8 Telefon / Navi NF in – 14 CDC Data-OUT

3Line Out GND 9 Radio / Navi Mute active (low) 15 +12V Permanent

4Line Out LF 10 +12V switched voltage* 16 +12V switch voltage*

5Line Out RF 11 Remote Control-In 17 CDC Data-GND

6+12V switch voltage* 12 Remote Control-GND 18 CDC AF-GND

19 CDC AF- L

20 CDC AF- R

* Sum. total 300mA

262

Relais

12V

Tel.-Mute (active low)

Speedometer signal

Back-up light signal

8 604 390 045

Wheel sensor

(required for vehicles without

a speedometer signal only)

Control cable (Power Antenna +)

The control cable is the connected positive output for

auxiliary components e.g.: power antennas,

(maximum load < 150 mA).

Important! Do not connect the control cable to terminal 15

(Plus connected) or terminal 30 (continuous plus).

Ground

Do not connect the ground wire (min. cross-section 1.5 mm2)

to the negative terminal of the battery.

Lay the ground wire to a suitable ground (chassis screw,

chassis metal) and screw it down.

Continuous plus connection (terminal 30 battery + 12 V)

Lay the plus wire (cross-section min.1.5 mm2) to the bat-

tery (not directly along the wire harnesses). Connect the

fuse holder to protect the plus wire and connect it to the

positive terminal on the battery.

Illumination connection

Illumination connection for vehicles with variable instrument

lighting (plus regulated).

Fig. 10

This information is subject to change without notice!

terminal

15 +12V

12V

Plus connection (connected to the ignition)

This connection must be made via the ignition

(terminal 15, +12V).

Country: Phone: Fax: www:

Germany (D) 0180-5000225 05121-49 4002 http://www.blaupunkt.com

Austria (A) 01-610 390 01-610 393 91

Belgium (B) 02-525 5454 02-525 5263

Denmark (DK) 44 898 360 44-898 644

Finland (FIN) 09-435 991 09-435 99236

France (F) 01-4010 7007 01-4010 7320

Great Britain (GB) 01-89583 8880 01-89583 8394

Greece (GR) 0030-210 57 85 350 0030-210 57 69 473

Ireland (IRL) 01-4149400 01-4598830

Italy (I) 02-369 6331 02-369 6464

Luxembourg (L) 40 4078 40 2085

Netherlands (NL) 023-565 6348 023-565 6331

Norway (N) 66-817 000 66-817 157

Portugal (P) 01-2185 00144 01-2185 11111

Spain (E) 902-120234 916-467952

Sweden (S) 08-7501500 08-7501810

Switzerland (CH) 01-8471644 01-8471650

Czech. Rep. (CZ) 02-6130 0441 02-6130 0514

Hungary (H) 01-333 9575 01-324 8756

Poland (PL) 0800-118922 022-8771260

Turkey (TR) 0212-3350677 0212-3460040

USA (USA) 800-2662528 708-6817188

Brasil (Mercosur) (BR) +55-19 3745 2769 +55-19 3745 2773

Malaysia (Asia Pacific) (MAL) +604-6382 474 +604-6413 640

Blaupunkt GmbH

01/03 CM/PSS 8 622 403 332 Index C (E/P/GB)

Blaupunkt DX-R52 Owner's manual

Brand: Blaupunkt

Model: DX-R52

Category: Car media receivers

Type: Owner's manual

This manual is also suitable for

Download PDF

report

Blaupunkt DX-R52 Owner's manual

This manual is also suitable for

Blaupunkt DX-R52 Owner's manual

Related papers

Other documents