SETUP INSTRUCTIONS
1) Remove station from the box and position it sink-side down on the ground so that the support
legs are accessible.
2) Find the outermost leg assembly, and pull outward from the rubber foot end. The leg assembly
will unfold until it is at a right angle to the station.
3) You will find two support struts where the leg assembly meets the table. Make sure that both
are locked completely straight to ensure the stability of the station.
4) Repeat this same process with the innermost leg assembly.
5) Once complete, flip the entire station upside down so that both sets of feet are resting on the
ground and the sink side is now facing upward.
1) Take out the whole faucet and count all components.
2) Put the faucet thread through the steel cover and rubber washer, then insert into the
holein the table .
3) Attach the rubber washerto the faucet thread, then screw the plastic thread joints tightly.
4) Screw the pipe connectionwith the two black washers ( and ) to the faucet tightly.
5) Connect the water hose to the pipe connection.
Step 1: Station Setup
Step 2: Faucet Assembly
1 2 3
4
5 1
8
8
7 9
6
1
MULTI-USE OUTDOOR TABLE
18200
Spray tabletop with water and whisk with a soft bristle brush. Disassemble the drain and remove
the faucet. Allow to dry thoroughly before storage. Unlock legs and fold.
To extend the life of this product, it is recommended to store in a dry location.
Step 4: Cleaning and Storage
1) Assemble the drain pipe with the thread joints and washerby screwing.
2) Twist the screwthrough the steel plate , large black washerand the table sink hole .
3) Attach the assembled drain pipe (, and ) to the screw and twist tightly.
Step 3: Drainer Assembly
10 11
12
13
15
16
14
16
10
14 15
11 12
13
14 15 16 10
Limited Manufacturer Warranty
FOT makes every effort to ensure that this product meets high quality and durability
standards. FOT warrants to the original retail consumer a 1-year limited warranty
from the date the product was purchased at retail and each product is free from
defects in materials. Warranty does not apply to defects due directly or indirectly
to misuse, abuse, negligence or accidents, repairs or alterations, or a lack of
maintenance. FOT shall in no event be liable for death, injuries to persons or
property, or for incidental, special or consequential damages arising from the
use of our products. To receive service under warranty, the original manufacturer
part must be returned for examination by an authorized service center. Shipping
and handling charges may apply. If a defect is found, FOT will either repair or
replace the product at its discretion.
DO NOT RETURN TO STORE
For Customer Service:
Email: [email protected] or Call 1-800-348-5004
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Max Load 36008 User manual
-
SPEEDWAY 33010 User guide
-
-
Steel Core 39807 User manual
-
-
Rinnai RHFE-1001FA Installation guide
-
-
-
-