Part List
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Hardware List
Key Wrench
1 pc.
A.
Top
1 pc.
B.
Support
1 pc.
C.
Support
1 pc.
Small
Hex Wrench
1 pc.
M8x40
Head Cap Bolt
8 pcs.(+1 extra)
M6x40
Head Cap Bolt
(long)
4 pcs.(+1 extra)
Flat Washer
4 pcs.(+1 extra)
M6x20
Head Cap Bolt
(short)
1 pc. (+1 extra)
E.
Base
1 pc.
F.
Base
1 pc.
D.
Leg
4 pcs.
Dining Table
88 5601 32
Home Styles Consumer Assistance: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Tools recommended for assembly : Level
Assembly Instructions 2/3
STEP 1
Attach Base (E) to Base (F)
with Head Cap Bolt (short).
(See Figure 1)
STEP 2
IMPORTANT
* Do not tighten up all the screws until each part is properly assembled.
* You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Use a soft cloth between these parts and the floor.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
F
E
Head Cap Bolt (short)
Head Cap Bolt
D
D
D
D
Attach Legs (D) to base unit
with Head Cap Bolts.
Figure 1
Figure 2
Assembly Instructions 3/3
Turn unit to its’ upright position.
Attach Supports (C) and (B) to unit
with Head Cap Bolts.
STEP 3
STEP 4
Head Cap Bolt
Head Cap Bolt
(long)
Flat Washer
B
C
Place Top (A) upside
down on a soft cloth.
Attach unit to Top (A) with
Head Cap Bolts (long) and Flat Washers.
Turn the table over to its’ upright position.
To level the table, adjust the adjustable
levelers on the bottom of legs.
(See Figure 2)
A
Frozen precipitation may damage the top. Store inside in freezing weather.Note:
/
