Miller GYRO BAIL GB-1 Owner's manual

Type
Owner's manual

This manual is also suitable for

OWNER’S MANUAL
FORM: OM-713 110 884B
June 1993
Gyro Bail-10/20 (041 978)
ST-112 844-C / ST-800 187
WARNING
ELECTRIC SHOCK can kill.
Do not touch live electrical parts.
Turn Off spot welder and input disconnect device.
Disconnect input power conductors from
deenergized supply BEFORE moving spot welder.
MOVING PARTS can cause injury.
Keep away from pinch points.
Part
No.
Item
No.
Description (Qty)
1 601 965 Screw, 3/8-16 x 1 (10)
2 602 213 Washer, 3/8 split lock (9)
3 125 883 Mounting Bracket LH (1)
4 125 882 Mounting Bracket RH (1)
5 125 884 Suspension Yoke (1)
6 110 510 Eye Bolt (1)
7 605 181 Nut, 3/8-16 (3)
8 601 871 Nut, 3/8-16 jam (8)
9 602 243 Washer, 3/8 flat (8)
10 079 240 Screw, 3/8-16 x 1-3/4 (2)
11 125 885 Gyro Bail Bracket (2)
12 110 509 Ring (1)
13 024 665 Bearing (4)
14 602 221 Washer, 3/8 tooth lock (4)
Be sure to provide Model when ordering re-
placement parts.
Remove front two hose clips from left
side of the spot welder and route
coolant hoses through the holes pro-
vided in the mounting bracket (3).
Adjust the pivot point or tilt angle of
the spot welder by loosening the two
self–locking nuts (7) and sliding the
spot welder along the gyro bail
brackets (11).
Tools Needed:
9/16, 5/8 in
5
1
2
3
4
6
7
10
9
8
2
1
2
11
7
2
9
1
12
13
14
2
8
18
Figure 1. Gyro Bail-10/20 Assembly
  • Page 1 1

Miller GYRO BAIL GB-1 Owner's manual

Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI