18V BACKPACK CHEMICAL
SPRAYER
PULVÉRISATEUR DE PRODUITS
CHIMIQUES DORSAL 18 V
ROCIADOR DE SUSTANCIAS
QUÍMICAS CON MOCHILA DE 18 V
P2804
NOTE: These instructions replace the REPLACING SEALS instruc-
tions located on page 11 in your operator’s manual.
WARNING:
This insert sheet is not a substitute for reading the operator’s
manual. To reduce the risk of injury or death, user must read and
understand operator’s manual before using this product. All page
references refer to the operator’s manual.
REPLACING SEALS
See Figure 1.
WARNING:
Always follow procedures for draining and cleaning the tank
before replacing the seals. Make sure you wear rubber gloves
when reaching into the chemical tank. Wash your hands thor-
oughly afterwards. Failure to follow these instructions can result
in a rash, skin irritation, or other serious personal injury if you
directly contact some chemicals.
Fig. 1
995000503
12-1-17 (REV:01)
Over time, seals can harden and crack, which can allow the chemical
sprayer to leak. A set of replacement seals is included. Refer to the
image shown for the location of each of the seals, then replace as
needed to address any leaks that develop.
Additional sets of replacement seals can be ordered by contacting
customer service.
NOTE: Unthreading the connections to replace the seals could allow
liquid to escape, so always clean the chemical sprayer thoroughly
as previously described before replacing the seals.
Page is loading ...
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: Ryobi P2840 Le manuel du propriétaire
- español: Ryobi P2840 El manual del propietario
Related papers
Other documents
-
Echo MS-41BPD User manual
-
-
Roundup 190327 User manual
-
Smith Performance Sprayers 190452 User manual
-
RIDGID RD80944 User manual
-
Echo MS-300 Owner's manual
-
RL Flo-Master 996P User manual
-
RL Flo-Master 2202HD User manual
-
Milwaukee M18 SWITCH TANK 49-16-28PS User manual
-
Black Max BM802711 User manual
