Grate
Burner Tent
Tent Frame
Shield
Insert 3/4” Carriage Bolts into bracket on Legs
Make sure all
before fastening
four
tabs are inside slots
Qty:2
Hinge Pin
and Hitch Pin
Items to Assemble:
1 Grill Lid
2 Hinge Pin
2 Hitch Pin
Qty: 2
Qty: 2
Qty: 3
Items to Assemble:
1 Logo Plate with clips
1 Heat Indicator
1 Handle
3 Wing Nut, Metal
Eyelet End
Match-Holder
Place end of chain through hole, reattach coupling to end of chain.
Thread eyelet on other end of chain into loop of match holder.
Remove coupling from chain
Back of Grill
Eyelet End
Match-Holder
CAUTION
!
• Failure to install can in clip will cause hot
grease to drip from bottom of grill with
risk of fire or property damage.
Wheel attaches
in BOTTOM HOLE
on legs
Tank Retainer
1st: Unfold legs. Do not stand cart up until front panel is attached. The front panel stabilizes
the cart.
Qty: 2
Qty: 1
Items to Assemble:
2 Wheels
1 Tank Support
2 Axle Bolts
2 Hitch Pins
2 Hub Caps
1 Tank Retainer
1 1-1/4” Carriage Bolt
1 Wing Nut
2 Control Knobs
1 Rotary Ignitor
Qty: 2
1st Remove styrofoam pad
1-1/4” Carriage Bolt
Using the Charcoal Pan
Remove the warming rack and burner tents.
See pages 24 and 25 in the Use & Care
Manual for Charcoal/Gas use.
463838403
Rotary Knob may be attached
Hub on wheel faces into leg.
Attach in bottom hole on leg
with axle bolt and hitch pin.
Qty: 7
Items to Assemble:
1 Upper Panel
4 2” Carriage Bolts
4 Wing Nuts
1 Lower Panel
3 2” Carriage Bolts
3 Wing Nuts
Lower Panel inserts into Upper Panel
Slide Upper Panel
under UFC
Stand Cart Upright
Items to Assemble:
1 Left Shelf
2 3/4” Carriage Bolts
2 Wing Nuts
2 Wing Screws
Qty: 7
Qty:2
Qty:2
Items to Assemble:
1 Sideburner Toolholder
1 Sideburner
2 3/4” Carriage Bolts
4 Wing Screws
Underside of shelf and toolholder
Tabs on toolholder
lock into sideburner shelf
Qty:2
Qty:2
Qty:4
View looking down on 3/4” Carriage Bolts
Item to Assemble:
1 Condiment Wire
1 Condiment Tray
Items to Assemble:
1 Charcoal or Grate Holder
1 Shield
2 Tent Frames
2 Burner Tents
1 Grate
Hang the grate or charcoal pan when not in use
on the hooks.
A
B
A Rotate grate support wires up and insert into holes on charcoal pan
A
B Rotate warming rack
leg wire to back of grill
bottom
C Place warming rack
in upper position
on the wire grate
supports and the tray
onto tent frames in
grill bottom.
Items to assemble:
1 Chain with Coupling
1 Match-Holder
1 Grease Clip
Grease Clip
See Use & Care Manual for “Match Lighting Instructions”
Hang grease clip from center of grill bottom.
Use an empty soup can (not included) to hang from grease clip.
View looking down
Tank Support
Qty: 1
Items to Assemble:
1 Straight Wire
2 Clips
Attach clips on straight wire. Place wire
into lower hole on lid. Slide clips to lid sides.
Attach handles between second and third wire from ends.
Hook end of handle over back and pull to hook over front wire.
A Insert leg on warming rack into
grill bottom
B Place U-shaped wires on back of
warming rack over straight wire.
D Flex leg wire down and forward to secure on hook of warming rack.
D
B
Items to Assemble:
2 Warming Rack Handles
1 Warming Rack Leg Wire
1 Warming Rack
C
C
Place leg wire into U-shaped
wire on front of warming rack.
Straight Wire
Remove Grates before attaching Warming Rack Leg Wire
Items to Assemble:
1 Sideburner Grate
1 Sideburner Knob
1 LP Tank
IMPORTANT
Proper
tube-to-valve
engagement
Insert Valve into Sideburner Tube and snap valve cup
into bottom of shelf. (See inset for proper engagement).
Place Sideburner Knob.
Attach long wire from beneath console
to electrode beneath Sideburner.
B
A
B
A
Loosen wing nut on tank retainer. Center base of LP tank
in notches on the tank support. Lower tank holder onto tank
and tighten the wing nut.
C
C
CAUTION
!
• Tank collar opening must face to front of cart
once tank is attached.
• Failure to install tank correctly may allow gas
hose to be damaged in operation, resulting in
the risk of fire.
LP tank is shipped empty. Fill and leak check before
attaching to grill and regulator.
See Use & Care to perform the “Burner Flame Check”
and important safety instructions before using.
1
9
12
11
10
9
8
4
5
6
7
1
2
3
/