Garden Oasis 534-4284-FS111-1 Owner's manual

Brand: Garden Oasis

Model: 534-4284-FS111-1

Type: Owner's manual

See our extensive assortment of outdoor living products

on-line at www.sears.com and www.kmart.com

OWNER’S

MANUAL

Panorama 9pc Dining

Set-Slate Table

Date of purchase: _____/ _____/ _____

Caution: Carefully Read Instructions and

Procedures for Safe Operation

Product Code: D71 M80259

KSN: 01331387-9

UPC code: 050874 290991

Made in / Hech en CHINA

Distributed by Sears, Roebuck and Co., Hoffman Estates, IL 60179

sears.com

For questions or comments about product:

Email: www.agio-usa.com or Call toll-free: 1-800-416-3511

Please refer to part numbers when reordering

5 2

Step 5: With the help of another person, carefully place the natural stone table top onto the table base.

Guide the bolts in natural stone table top (assembled in Step 2) into the holes of the “L” metal

brackets

as shown in Fig. 4. After making any necessary adjustments to the alignment of the

bolts in the natural stone table top and the “L” metal brackets, add a nuts, spring washers and

Ø18x1.5 mm washer to the end of each bolts, as shown in Fig. 5, and tighten. Do not over

tighten.

Your table is now ready for use. If you have any questions, please call our Customer Service Center

at 1-800-416-3511.

IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or imporper

assembly is not covered under our warranty. Please read all instructions carefully before assembly.

f you have any questions regarding your assembly, call our Customer Service Center at 1-800-416-3511.

IMPORTANT!! PLEASE READ ENTIRE

INSTRUCTION SHEET BEFORE ASSEMBLY!!

TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE

KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT

Step 1: Remove all protective materials and set parts on a flat, non-abrasive surface. Identify parts

packed in carton against the parts list. If you are missing any parts or are unsure as how to

proceed with the assembly, Please call our Customer Service Center at 1-800-416-3511.

Do not attempt assembly if any parts are missing or damaged.

Step 2:

Place the natural stone table top upside down on a flat, non-abrasive surface. Insert four

1/4”x35 mm headless

bolts into the pre-drilled hole on the underside of the natural stone

tabletop as shown in Fig. 1 Do not over tighten.

Step 3: Attach a leg to the connector bracket. Add Ø6.5x1.0 mm washers and

spring washers to

1/4”x35 mm

bolts and carefully guide the bolts through leg connector bracker and into the

pre-drilled holes in the table leg (each leg uses four bolts--two on each side) as shown in

Fig. 2. Do not over tighten. Repeat on remaining leg.

Step 4: Attach “L” metal bracket to top base using two 1/4”x18 mm bolts and spring washers and

Ø6.5x1.0mm washers as shown in Fig. 3. Guide bolts through holes in “L” metal bracket

and into pre-drilled holes in the top base. Do not over tighten. Repeat for remain “L” metal

brackets.

Garden Oasis 534-4284-FS111-1 Owner's manual

Garden Oasis 534-4284-FS111-1 Owner's manual

Garden Oasis 534-4284-FS111-1 Owner's manual

Related papers

Other documents