AGFA AF5089 Owner's manual

Page is loading ...

1

EN

Introduction 2

Safety Instructions and Recom-

mendations

Do not make any changes or settings that are not

described in this user manual. Physical injury or

damage to the device or loss of data can result

from improper handling. Take note of all warning

and safety notes indicated.

The device is exclus ively for indoor use only.

The device is exclusively for indoor use only. The

device should rest securely on a stabile, flat sur-

face. Position all cables in such a way that no one

will stumble on them, thus avoiding possible inju-

ries to persons or damage to the device itself.

LCD screen

Always handle the unit with care. Avoid touching

the LCD screen. Never place heavy or sharp ob-

jects on the LCD panel, frame or power cord.

Protect the dev ice against direct sunlight

Protect the device against direct sunlight, heat,

large temperature fluctuations and moisture. Do

not place the device in the vicinity of heaters or air

conditioners. Observe the information on temper-

ature and humidity in the technical data.

Do not switch the device on immediately after tra nsporting it.

The device should not be switched on immediately

after being moved from a cold to a warm room or

vice versa or into a cold room which has been

heated up quickly. In such cases, wait at least

three hours until the device has adapted to the

changed conditions (temperature, humidity…) .

In the event th at the device becomes too hot, or if you see smoke coming from the devi ce

In the event that the device becomes too hot, or if

you see smoke coming from the device, you must

immediately pull the power cable out of the power

socket. Have your device examined by trained pro-

fessionals at a technical service location. To pre-

vent the spread of fire, open flames should be

kept away from the device.

Do not p lug in the devi ce in moist roo ms.

Do not plug in the device in moist rooms. Never

touch the mains cable or the mains connection

with wet hands.

Do not allow liquids to enter into the device.

Do not allow liquids to enter into the device. Dis-

connect the device from the power socket if liq-

uids or foreign objects have entered the device

and have your device examined by trained profes-

sionals at a technical service location.

Do not allow children to handle the device withou t supervision.

Do not allow children to handle the device without

supervision. The packing materials should be kept

out of the hands of children.

Use only the encl osed power adapter

Use only the enclosed power adapter (see chapter

Appendix / Technical Data). Check whether the

mains voltage of your device (indicated on the

type label) matches the mains voltage available at

the setup location. This equipment complies with

the voltage type specified on the unit.

Never touch the power cable if the insulation is da maged.

Never touch the power cable if the insulation is dam-

aged. Replace damaged wires immediately. Use suit-

able cables only; if necessary please contact our

technical customer service or your retailer.

Before cleaning the surf ace of your device, disconnect it from t he power network.

Before cleaning the surface of your device, dis-

connect it from the power network. Use a soft,

lint-free cloth. Never use liquid, gaseous or easily

flammable cleansers (sprays, abrasives, polishes,

alcohol). Do not allow any moisture to reach the in-

terior of the device.

Only clean the display with a dry, soft cloth.

Only clean the display with a dry, soft cloth. If the

display breaks, a mildly corrosive liquid may es-

cape. Avoid all contact with your skin and eyes.

Repairs

Do not make any repairs to the device yourself.

Improper maintenance can result in injuries or

damage to the device. Only have your device re-

paired by an authorised service centre.

Do not remove the type label from your device;

this would void the warranty.

Photo Memory Media

Only use storage media that are compatible with

the device. In order to prevent damage to the card

or the unit, please turn off the power before re-

moving or inserting the card.

Never pull out the memory card while the device is

accessing it. This could cause data to be damaged

or lost.

Packing Contents

Digital photo frame with bracket

Power supply with exchangeable plugs

Quick Start Guide

Warranty Card

Basic Operation (fig. 1)

1 If there is a protective foil on the frame, please

remove it before attempting to use.

2

Insert a memory card or a USB storage medium

into the appropriate slot at the rear of the device.

3

Insert the small plug of the power supply into the

socket

Í

on the rear side of your device. In-

sert the power supply unit into the socket.

4 Switch the device on using the on/off switch

B on the rear. Buttons on the Front of the De-

vice (fig. 2)

ü/þ—Navigating in the Menu / Skips to the pre-

vious or next image, music or movie.

ú—Switch on the background music during slide

show

N

otice

Connecting to an Computer

Using the USB cable (USB 2.0 A / Mini

B), you can connect your photo frame

to a computer to transfer files between

the internal memory and computer.

Page is loading ...

AGFA AF5089 Owner's manual

This manual is also suitable for

AGFA AF5089 Owner's manual

in other languages

Related papers

Other documents