BLODGETT
www.blodgett.com
1100 Old Honeycutt Road Fuquay-Varina, NC 27526 USA
Phone: (877) 255-3976 • Fax: (866) 644-1354
SPECIFY
Gas Type Natural Gas Propane
Manifold Front (1-1/4”) Rear (1”)
Range Depth Standard Deep (option)
Position in Battery Left End Right End Not at End
Electric Power (ovens) 120V 208/240V
Operating altitude (if above 2000 ft (700 meters) _____________________
Blodgett can often accommodate special or custom requirements. Contact your
Blodgett representative.
STANDARD FEATURES
Exclusive Perfection-Schwank infra-red burners with 104,000 BTU rating
90 second preheat time with no waiting between loads
Stainless-steel front and sides with baked-on black enamel top and rear
Broiler grid is 24-1/2” wide and 28” deep, and easily rolls out 17-1/4”
Rugged four position grid-height adjustment mechanism
Warming oven (heated by broiler flue gases) is 25” wide and 25” deep
Fully insulated lining and burner boxes
45,000 BTU oven with electronic pilot ignition
Cool-to-the-touch oven handle
Two oven racks (2-1/4" between each of five positions)
“Insta-On” thermostat with a wide range of 150°F to 500°F
6" adjustable legs
Warranty: two year parts and labor from date of purchase
INFRARED BROILERS
With Overhead Warming Oven and
Sectional Base
INFRARED SECTIONAL BROILERS
Project
Item No.
Quantity
Model B32D-171 (Standard Oven Base)
Model B32A-171 (Convection Oven Base)
Blodgett infrared broilers broil in half the time with 1/3 less gas than ordi-
nary broilers. The burners reach operating temperature in just 90 seconds,
and their intense infrared energy quickly heats the food, not the surround-
ing air. The broiling grid adjusts to four heights, and rolls out for easy
access. A blower delivers fresh, filtered air to prevent smoke and vapors
from affecting broiling efficiency. An overhead warming oven is heated by
the broiler flue gases (or by an optional electric heating element). The base
can be either a convection oven or a standard oven. Battery-design assis-
tance is available!
Model B32D-171
OPTIONS AND ACCESSORIES
(AT ADDITIONAL CHARGE)
Electric heating element for warming oven
Stainless steel back
Casters (in lieu of legs)
Cable restraint kit for units on casters
Additional oven racks
Open frame base with casters
BLODGETT
www.blodgett.com
1100 Old Honeycutt Road Fuquay-Varina, NC 27526 USA • Phone: (877) 255-3976 • Fax: (866) 644-1354
INFRARED SECTIONAL BROILERS
SHORT FORM SPECIFICATIONS
The item shall be an infrared broiler with an overhead warming oven with a (standard oven) (convection oven) sectional base. The broiler burners shall total 104,000 BTU with separate
controls. The (front and sides/front, sides and back) shall be constructed of 430 stainless steel #3 polish. The lining and burner boxes shall be fully insulated. The roll-out broiler grid shall
be 24-1/2” wide and 28” deep and have four height positions. The item shall have a 25” wide by 25” deep warming oven heated by the broiler flue gases. The item shall have 6” adjustable
legs (casters). If the item is at the end of a bettery, the end side shall be solid (rather than have a coverplate over the end of the front manifold).
Model 32A: The item shall have a 45,000 BTU convection oven with electronic ignition and a thermostat range of 150°F to 500°F (66°C to 260°C). The oven interior shall be porcelain,
measure 14" high x 26" wide x 24" deep, and have two racks with five-position side-rails with 2-1/4" between positions. The blower fan shall have two speeds and a 1/3 hp motor.
Model 32D: The item shall have a 45,000 BTU standard oven with electronic ignition and a thermostat range of 150°F to 500°F (66°C to 260°C). The oven interior shall be porcelain,
measure 14" high x 26" wide x 26.5" deep, and have two racks with five-position side-rails with 2-1/4" between positions.
Printed in U.S.A. NOTE: FOR COMMERCIAL USE ONLY
NOTE: The company reserves the right to make substitutions of components without prior notice
P/N BR00030 Rev C (7/07)
OTHER TECHNICAL INFORMATION
Exterior surfaces are 430 stainless steel #3 polish, except the back is aluminized steel.
The front 3" of the broiler grates receive less heat and so can be used as a holding area.
On oven models, a gas valve for the oven is located on the front panel above the oven. The oven control panel is located to the left of the oven door and includes an on-off switch, indi-
cator light, thermostat knob, and (on convection ovens) a speed selector switch for the blower motor. The fan motor for convection ovens is 1/3 hp, 2-speed, 1725/1140 rpm, with over-
load protection. Check local codes for fire and sanitary regulations.
UTILITY INFORMATION
GAS: Each unit has a 1-1/4" front gas manifold that couples to the adjacent sectional unit(s), and can be
ordered with a 1" rear gas connection with a male NPT connector. Minimum supply pressure is 7" W.C. for
natural gas, 11" W.C. for propane. An external pressure regulator and shut off valve must be provided. If
using a flexible-hose gas connection, the I.D. of the hose must not be smaller than the connector on the unit
and must comply with ANSI Z21.69. Provide an adequate means of restraint to prevent undue strain on the
gas connection.
ELECTRICITY: Both standard-oven and convection-oven models require electric power (50Hz or 60Hz single-
phase AC). 120V models have a 7-foot (2134 mm) power cord with a grounded plug. 208/240V models have
a terminal block for connection to a single-phase 208/240V source.
FLUE EXHAUST: Installation under a vented hood is recommended.
MODEL
GAS (BTU/hr) ELECTRICITY (amp)
Natural Gas Propane 120V 208/240V
B32A-171 149,000 146,000 5.8 3.6
B32D-171 149,000 146,000 2.0 2.0
APPROVAL/STAMP
-
1
-
2
Blodgett B32A-171 Datasheet
- Type
- Datasheet
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Blodgett B32D-171 Operating instructions
-
Blodgett B32A-3240 Datasheet
-
-
Blodgett B48-NFR Datasheet
-
Blodgett B36D-BBB Datasheet
-
Blodgett B36C-BBB-SU Datasheet
-
-
Blodgett B36C-GRAD Datasheet
-
-