3com Baseline Switch 2426-PWR Plus Release note

Brand: 3com

Model: Baseline Switch 2426-PWR Plus

Type: Release note

3Com Baseline Switch 2426-PWR Plus

Release Notes

Software version 1.0.0.8

Part Number: 10015457 Rev. AB

Published Date: January 2007

1. Introduction

1.1 Scope

These release notes summarize the operational requirements and known issues for the

following 3Com Baseline Switch 2426-PWR Plus /software releases.

Software Release Filenames Description

1.0.0.8

Initial Release Operational Software

3Com Baseline Switch 2426-PWR Plus

Model # 3C16491

Note: The software does not operate with any other

3Com Switch.

1.2 Online Resources

To obtain a copy of the 3Com Baseline Switch 2426-PWR Plus User Guide, visit the

3Com Web site:

www.3com.com

where you can find the most up-to-date version.

To obtain the latest technical information for your Switch, including a list of known

problems and solutions, visit the 3Com Knowledgebase:

http://knowledgebase.3com.com

To obtain current software updates (maintenance releases) and associated release

notes for the 3Com Baseline Switch 2426-PWR Plus and other 3Com products, visit the

3Com Web site:

http://www.3com.com

3Com Baseline Switch 2426-PWR Plus v1.0.0.8 Release Notes

Page 2 of 2

2. Known Issues for 3Com Baseline Switch 2426-PWR

Plus Release v1.0.0.8

2.1 Port Modes

• Ports which are in auto mode or manual mode can be added to trunks.

2.2 ImageDownload

• If you download an incorrect image for Web upgrade, the Switch does not display an

error message and continues to function normally.

2.3 Limited SNMP Support

• The Switch has limited SNMP support in this release.

2.4 Cable Diagnostics

• Cable diagnostics do not work for the Gigabit ports.

3. Upgrading Software

To upgrade the software in the 3Com Baseline Switch 2426-PWR Plus, perform the

following procedure:

1. Obtain (i.e., download) the appropriate upgrade file for your device.

The upgrade file available from the 3Com web site is provided in an EXE format.

Please run the executable to reveal the upgrade file.

2. Access the web administration interface by pointing your web browser at the IP

address for the switch.

3. Log in to the user interface. Default: Type “admin” in the username field and press

Return. (The default admin password is to leave the password field blank.)

4. Select the “Administration” tab on the menu on the left side of the page and choose

the Firmware Upgrade tab.

5. Click the “Browse” button, which will open a screen for you to select a filename to

load into the Switch. Select “Open”.

6. Click the “OK” button.

7. Follow the instructions in the popups for the remainder of the upgrade.

3com Baseline Switch 2426-PWR Plus Release note

3com Baseline Switch 2426-PWR Plus Release note

3com Baseline Switch 2426-PWR Plus Release note

Related papers

Other documents