3
2
STABLE ASSEMBLY
1. Place the Main Stable Unit upright on a table with the roof section facing you.
2. Raise the roof section and hold it up with one hand. (Fig. 1)
3. While holding the roof upward, use your other hand to swing the right Stable wall all the way around from
the back of the unit to the front. (Fig. 2)
4. While still holding the roof upward swing the left Stable wall all the way around from the back of the unit
to the front. (Fig. 3)
QUICK START
QUICK START cont‛d
FENCE ASSEMBLY
7. Snap together the two Fence sections. (Fig. 6)
8. Snap one end of the combined Fence section to the left wall of the Stable and the other end to the right
wall. (Fig. 7)
Fig. 8
Lamps
Fig. 11
5. Slowly lower the roof section until the top edges of the walls fit into the grooves underneath the roof
edge. (Fig. 4)
6. Snap the Additional Wall unit onto the right edge of the Main stable Unit. (Fig. 5)
ASSEMBLING ACCESSORIES
9. Fit the peg on the top of the Chandelier into the opening under the center of the Stable roof and press
firmly. (Fig. 8)
10. Fit the pegs of each of the 3 Lamps into the openings on the outside walls of the Stable. (Fig. 9)
11. Fit the long peg on the Feed Box into the slot under the window of the Additional Wall unit then press
the Feed Box downward until the two smaller pegs fit into the openings provided. (Fig. 10)
NOTE: Feed Box can be placed on either the inside wall or outside wall of the stable.
12. Hang the Broom and Pitchfork on the pegs provided inside the Stable. (Fig. 11)
13. Place the Scissors and other items on the shelf inside the Stable. (Fig. 11)
Your Stable is now assembled. Walk your horse inside, take off its saddle by unsnapping the cinch strap
underneath the horse‛s tummy and groom its mane and tail with the Grooming Brush. Then give it a carrot as
a treat!
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Fig. 5
Fig. 7
Fig. 6
Fig. 9
Fig. 10