CyberData 011523 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the CyberData 011523 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Quick Reference 931750A © 2020, CyberData Corporation, ALL RIGHTS RESERVED.
Parts
FIts 24-inches x 24-inches and 24-inches x 48-inches ceiling tile
(1) Auxiliary Analog 2 x 2 Ceiling Tile Drop-In Speaker Assembly
Dimensions
23.8 [605]
23.8 [605]
Dimensions are in Inches [Millimeter]
3.6 [92]
Approximately
Contacting CyberData
Sales: (831) 373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website: http://support.cyberdata.net/
RMA Department: (831) 373-2601 ext. 136
RMA Email: [email protected]
RMA Status: http://support.cyberdata.net/
Warranty Information: http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
http://www.cyberdata.net/
The IP Endpoint Company
Installation Quick Reference
Auxiliary Analog 2 x 2 Ceiling Tile Drop-In Speaker
011523
© 2020, CyberData Corporation, ALL RIGHTS RESERVED. 931750A Quick Reference
Installation Procedure
To install the Auxiliary Analog 2 x 2 Ceiling Tile Drop-In Speaker, complete the following steps while referencing the
figure below:
1. Remove the Ceiling Tile (the figure below shows a 2 x 2 Grid) from the Ceiling Grid. Cut the 2 x 4 Ceiling Tile in
Half if using a 2 x 4 Grid.
2. Place the Cross T* in the Middle for Support (Only on a 2 x 4 Grid).
3. Use a Flat Blade Screwdriver to Pry the Seismic Tether Bracket(s) on the 2 x 2 Auxiliary Ceiling Tile Speaker
Assembly.
4. Install Eyebolt(s) or Nail(s) to the Joist.
5. Connect the Speaker Wire(s) to the Blinding Posts on the 2 x 2 Auxiliary Ceiling Tile Speaker Assembly.
6. Use Steel Wire(s) to Connect Seismic Tether Bracket(s) to the Eyebolt(s) or Nail(s). Place the 2 x 2 Auxiliary
Ceiling Tile Speaker Assembly on to the Ceiling Grid and the Cross T* (see Step 2).
Installing the Auxiliary Analog 2 x 2 Ceiling Tile Drop-In Speaker
Use a Flat Blade Screwdriver
to Pry Up the Seismic Tether Bracket
Joist
Eyebolt / Nail
*
*
*
*
Speaker Assembly
2 x 2 Auxiliary Ceiling Tile
Steel Wire
*
Remove
Ceiling Tile
1
Drop-in the 2 x 2 Ceiling Tile Speaker Assembly
6
3
4
5
Cross T
Install Cross T (Not Included)
Only on a 2 x 4 Grid
2
/