Automate SmartStart DSM50BTP1 Owner's manual

BLUETOOTH Module

BLUETOOTH

Module

! ATTENTION !

Read First

To start using SmartStart Bluetooth Passive Locking, follow these steps:

1. Launch app, go to More/Settings page and turn on the Bluetooth

Control switch.

2. On Cars tab, add or link your SmartStart Bluetooth PKE device fol-

lowing the instructions provided.

3. Once the Bluetooth device appears on your Cars page, turn on Pas-

sive Locking by pressing the “Enable Passive Locking” button.

Next, set your unlock and lock thresholds following the instructions pro-

vided.

1. For best results, the Lock and Unlock thresholds should be set at

least 10 feet apart. Setting them too close together may result in

excessive lock/unlock cycles.

Note: you must always set the Lock threshold further away from

the vehicle than Unlock. Failing to do this may cause the Passive

Locking feature to stop working.

2. If Passive Locking stops working, follow these steps to restart the

feature:

a. Disable Passive Locking using the app, then Enable it again.

b. Set the Lock and Unlock thresholds again, making sure that

Lock is set further away from the vehicle than Unlock, and that

the two thresholds are far enough apart to avoid overlap of

the Lock/Unlock actions.

This manual is also suitable for

Download PDF