T581

Tennant T581 User guide

  • Hello! I've reviewed the Tennant T581 Quick Guide. This document provides essential instructions for setting up, operating, and maintaining the floor scrubber. It covers everything from filling water and detergent and choosing cleaning modes to maintaining the machine, changing blades, and battery management. I'm ready to help with any questions you have about the content of this guide.
  • What should I do before using the machine?
    What daily maintenance tasks are required?
    How do I replace the squeegee blades?
    How do I attach and remove the brushes?
    What should I do when the machine is not used for more than seven days?
T581
Quick guide
This guide is intended for quick consultation only and does not replace the user and maintenance manual.
Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly follow all the
instructions.
PREPARATION & OPERATION
(See backside)
1
5
2
4
76
3
PLDC04437 Rev.01 (04-2021) EN
ON
CHEM
H2O
+
REPLACING THE SQUEEGEE BLADES
ATTACHING/REMOVING THE BRUSHES
Open the clip (Ref. 1).
Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.
Remove the blade.
Reuse the same blade by reversing the edge in contact with the oor until all four edges are worn out, or replace with a new blade, tting it onto the
screws on the body of the squeegee.
Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing
devices inwards.
Close the hook again.
Replace the squeegee on its support, following the instructions described previously.
Position the brush underneath the head, in the centre (single-brush oor
scrubber), position the brushes underneath the head on both sides (double
brush scrubber), switch the machine on.
Press the CLICK ON-OFF switch, once after starting the machine releases
the brushes, pressing the button a second time activates automatic
brush attachment. The button is only enabled when all the functions are
deactivated (suction motor and brushes).
DAILY MAINTENANCE
Clean the dirty
water tank.
Check the suction lter is
undamaged and clean.
Check that the
detergent outlet lter
is clean.
Check that the
brushes are
clean. Replace if
necessary.
Check that the
squeegee is clean
and the blades are not
worn.
PERIOD OF INACTIVITY: When the machine is not used for more than seven calendar days
disconnect the batteries from the machine by pushing the lever as indicated in the picture.
PLDC04437 Rev.01 (04-2021) EN
1
2
/