2. Product assembly instructions
1: place the bucket motherboard according to the bucket size in
bucket corresponding position, if there is a hole bucket on both sides
of the edge, it shall, in accordance with the reserved hole position will
bolt installation, product main board and bucket maintain tightness
state (note: if there is no hole on the bucket, it should be according to
the products are mainly on the holes punched on the bucket, then to
product for installation)
2: place the tooth tooth one by one according to the position of
the tooth root on the mainboard for installation;
3: put the pin in accordance with the reserved holes on the tooth
one by one, need to use a hammer to knock into the hole, ensure that
the pin is complete into the hole, ensure the installation and assembly
of the tooth and bucket;
4: Assembly is complete.
