Howard MWP Installation guide

Brand: Howard

Model: MWP

Type: Installation guide

Howard MWP is a versatile and efficient LED wall pack lighting solution designed for various outdoor applications. With its adjustable wattage output, ranging from 30% to 100%, you can customize the brightness to suit your specific needs. Moreover, the color temperature can be effortlessly switched between 3000K warm white and 5000K cool white to create the desired ambiance. Installation is straightforward with the included template for precise drilling and easy mounting to a wall or junction box. Ensure proper grounding for safe operation.

MWP Medium Wall Pack Installation Instructions

Instructions subject to

change without notice.

Howard Lighting Products | 580 Eastview Drive | Laurel, MS 39443

(toll free) 800.956.3456 | (direct) 601.422.0033 | (fax) 601.422.1652

www.HowardLightingProducts.com

1025-702006-998

Rev: 9/21/2022

WARNING:

Disconnect power during installation and before servicing.

This product must be installed in accordance with the applicable

installation code and by a person familiar with the construction and

operation of the product and the hazards involved.

SAFETY:

This fixture must be wired in accordance with the National Electric Code and

applicable local codes or ordinances.

All work should be performed by a qualified electrician.

To insure personal safety, proper grounding is required (connect green fixture

lead to supply ground).

IMPORTANT: Read all instructions carefully before attempting installation. If you do not understand these instructions, please consult your local distributor.

Thoroughly inspect the fixture for any freight damage; freight damage should be reported to the delivery carrier.

INSTALLATION

 Open the fixture by removing the two

screws located on the right side of the

housing. Then, lift the lens door off the

hinges and set it aside for later

reinstallation.

 Drill or knock out the appropriate holes

for mounting the fixture to the wall.

Also, drill holes for securing the fixture

to the junction box, using the 3 ¼” or 4”

junction box template shown in FIG-1.

Apply silicon sealant (not provided) to

any holes to prevent water entry.

 Secure the back of the fixture to the wall

using two or more screws and to the

junction box with screws. Ground the

fixture by connecting the green fixture

ground wire to the junction box ground

wire. Then, connect the white fixture

wire to the white supply wire (neutral)

and the black fixture wire to the black

supply wire (line).

 Replace the lens door back onto the

hinges of the fixture. Connect the driver

and LED assembly via the luminaire plug

shown in FIG- 2. Close the door and

reinstall the two screws on the right side

of the fixture.

 Remove the plugs from the weep holes

located on the bottom left and right side

shown in FIG-3 of the lens door to allow

water to escape the fixture.

FIG-1

Wattage Adjusting Instructions

For wattage selectable models, there is an

adjustable output unit (shown on the right)

inside of the fixture on the left that is

attached to the dimming leads that can be

used to adjust the wattage of the fixture.

Using a flat blade screwdriver turn the dial of

the adjustable output unit to the desired

output level. Position #8 corresponds to no

dimming. The chart below shows the

estimated input wattage at each position as a

percentage of the maximum input wattage.

FIG-2

AOU Position

Input Wattage

AOU Position

Input Wattage

100%

60%

90%

50%

80%

40%

70%

30%

FIG-3

CCT Selecting Instructions

For color selectable models, there is a switch

(shown on the right) attached to the back of

the LED assembly.

To change the CCT of the fixture, (with

supply voltage turned off) simply slide the

switch to the desired color. 5000K is the

coolest setting, while 3000K is the warmest

setting.

Howard MWP Installation guide

Howard MWP Installation guide

Howard MWP Installation guide

Other documents