-9+9-9+9-9+9
C-DRV
C-MIXMOJO TONE VINTAGE ASPECT
RATIO
50
SUB 1
BODY
BASS
SUB 2
TIGHTINSERT
AIRLF HF
SHEEN
BRITE
PRES
MIDS
GR
A•
N
MOJO C
COLOUR
VINTAGE switch alters high
frequency response to emulate
vintage British consoles.
20 segment meters show
output level of processed
signal for all Modes. When
monitoring MIX, but in BYP
mode, no signal will be
present.
HF Selector switch selects
between MIDS, PRES, BRITE,
and SHEEN frequencies.
MOJO Selector switch chooses
which MOJO amp is processing
the signal. The A and N amps
may be cascaded for maximum
MOJO.
MOJO AN switch engages the
Aand Namps at the heart of the
TONE-AMP™. When engaged,
A and/or N LEDs will illuminate to
show the active selection.
LF knob sets the amount of low
frequency boost/cut of Baxandall
TONE circuit up to +/- 9 dB.
HF knob sets the amount of high
frequency boost/cut of Baxandall TONE
circuit up to +/- 9 dB.
LF Selector switch selects between
SUB 1, SUB 2, BASS, and BODY
frequencies.
TIGHT switch engages 12 dB/oct
high pass filter.
TIGHT Frequency switch
selects between two high pass
filters: 12 dB/oct at 25 Hz with
slight resonant bump at 40 Hz
gives tape-like response for
mixes. 12 dB/oct Butterworth at
50 Hz is well suit-suited for
tracking.
GAIN knobsdrive the input
of the Aand NMOJO
stages.
OUTPUT knobs attenuate
the output level of the Aand
NMOJO stages.
MODE Selector switch chooses
which set of inputs and outputs
are being processed through the
TONE-AMP™. The BYP setting
can be used as a global hard
bypass for the MIX path.
POLARITY switch reverses
polarity of both MICROPHONE
input signals.
48V switch engages phantom
power for both MICROPHONE
inputs.
ASPECT RATIO switch alters
the relationship between width
and height of the stereo image.
INSERT switch activates and
bypasses the rear-panel inserts
as a function of MODE Selector
and internal jumper J15.
AIR knob sets the amount of Air
boost/cut circuit up to +/- 9 dB.
MOJO C / COLOUR switch
activates analog plugin
(expansion) slot when either C
Mojo Amp or Colour modules are
installed. When “C” module is
active, the C LED will illuminate.
The RGB LED next to the switch
illuminates with unique color
programmed by module.
SWAP LED
illuminates when
MOJO selector is
set to N>A.
C-DRV knob simultaneously
controls input gain of the C
module, and post-module
attenuation to maintain a musical
loudness taper (approximately
unity gain).
C-MIX knobs controls intensity of
C module effect by blending
processed and dry signal.
Turning the knob clockwise mixes
in more of the C module’s effect.
TONE switch engages 3-band
Baxandall EQ circuit. LED
illuminates when engaged.
© 2021 LOUDER THAN LIFTOFF LLC. ALL RIGHTS RESERVED
/
