2. MGC
  3. QBB-6001

MGC QBB-6001 User manual

  • Hello! I've reviewed the installation instructions for the MGC Audio Enclosure QBB-6001. This document details how to install the enclosure, mount the door either left or right and includes important information about wiring through the knockouts as well as attaching the Mircom label and warning label. I'm ready to answer your questions about the installation process.
  • What does the QBB-6001 consist of?
    Can the door be installed to open either left-to-right or right-to-left?
    Where should the warning label be placed?
LT-6692 Rev 0 July 2022 Page 1 of 3
QBB-6001
Expansion Audio Enclosure
Installation Instructions
Installing the QBB-6001 Expansion Audio Enclosure
The QBB-6001 expansion audio cabinet is surface mounted. The QBB-6001 consists of the backbox and door.
Install all cabinets and enclosures empty. Pull all required wiring in through the conduit holes provided (must be
punched out). Do not mount the modules until mechanical installation is complete and all wires have been fed into
the cabinets and enclosures.
Figure 1: QBB-6001 Dimensions, Mounting Holes and Knockouts for Installation
Note: It is extremely important to connect the audio cabinet’s earth-ground point (chassis
ground) to the earth ground. Conduits should be brought in only through the
knockouts provided in the backbox.
45.9”
22.4”
44.3”
9”
7.6”
20”
16”
40.2”
4 Mounting Holes as shown
i
LT-6692 Rev 0 July 2022 Page 2 of 3
Attach Mircom Label to Door
You can install the door so that it opens either way: left to right, or right to left. There are six holes in the door so you
can attach the metal Mircom label to either side, depending on how the door is installed.
Figure 2: Holes for the Mircom Label
1. Remove the adhesive backing from the metal Mircom label.
2. Attach the label to the bottom of the door by sliding the studs on the label through the holes.
3. From the inside of the door, use pliers to push the washers on to the studs. Push the flat sides of the washers
against the door.
Figure 3: Attach the Mircom Label to the Door
Position of the
Mircom label when
the door is installed
with hinges on the
left
Holes for the
Mircom label when
the door is installed
with hinges on the
right
Push washers on
the label studs
with the at side
against the door
Inside of door
LT-6692 Rev 0 July 2022 Page 3 of 3
Attach Warning Label to Door
To comply with CAN/ULC-S527, attach the included warning label to the door over the keyhole, as shown below.
Figure 4: Attach the Warning Label to the Door
Align the label over the keyhole
Door
Warning label
/