RACKBUDDY
SHELF
rackbuddy.com
INSTRUCTIONS
1
2
4
3
Mark the holes in the “Flanges” on
which surface the shelf should be
placed.
Use a spirit level to keep the shelf
hanging straight.
Depending on the surface; holes
must be pre-drilled for plugs and / or
“Flanges” fastened with screws.
Collect “shelf-carry-arms”.
Place the shelf in the desired position
and mark the holes with a pencil.
Check if shelf is level with
spirit level - if not, adjust
the flanges accordingly.
Mount the shelf with the screws.
Pre-drill the holes in the shelf, with a
3,5 or 3 mm drill.
Be careful not to drill through!!
/
