Page is loading ...
Instructions
®
BUILT TO ENABLE. CREATED TO INSPIRE
BOWL
75 mm
HALF
Look at your box.
See that little sticker
with a serial number
and a barcode? Peel
it o and put it here
for safe keeping.
Or don’t.
IMPORTANT
DO NOT USE YOUR 75 MM
HALF BOWL UNTIL YOU HAVE
READ THESE INSTRUCTIONS.
NO WARRANTY CLAIM WILL BE
ENTERED INTO FOR THE MISUSE
OR INCORRECT USE OF THESE
PRODUCTS.
1 -3/8”-16 Thread
2 - Support Screws
3 - Bubble Level
4 - Locking Handle
5 - 3M O-Pads
6 - Knurled Hook
To enable attachment to tripod heads, the 75mm Half
Bowl features a standard 3/8”-16 thread on the top.
For extra security there are 3 support screws
which when tightened up give an extra secure
connection between the bowl and a head.
The underside of the bowl has cut out points
which give access to the support screws for
loosening or tightening with the use of an allen
key.
The Half Bowl features a bubble level to ensure
the head is positioned correctly.
ANATOMY OF 75 MM HALF BOWL
2
2
5
The base of the Half Bowl’s handle has a knurled hook that can be used for hanging
additional weight to increase the stability of your tripod if needed.
The hook can also be removed to provide a further female 3/8”-16 mounting point
for additional accessories.
Unit 2A Kinsbourne Farm
Bury End
Stagsden
Bedfordshire
MK43 8TS
United Kingdom of
Fadeless Splendour
3LT Social Media
#3LeggedThing
/3LeggedThing
@3LeggedThing
/
