LEE DING LD-O01361 User manual

Hello, I've reviewed the Operating Manual for the Service creeper. This manual provides details on the product's specifications, installation, and maintenance. The creeper is designed for automotive repair, has a 200kg capacity, and uses 6 wheels for mobility. I'm ready to answer your questions regarding the device and its use.
What is the service creeper made of?

What is the bearing capacity of the service creeper?

How many wheels does the service creeper have?

Operating Manual of Service Creeper

I. Functions and Uses

Service creeper is a widely used equipment for automobile bottom repair and maintenance.

II. Product Information

Specifications:

Service creeper:

40 inches: 102 cm * 48 cm * 11. 5 cm

Note: Manual measurement, with slight error

Wheels: 3 inches (with 6 wheels and 1 set of screws)

Material: PE

Production process: Blow molding

Bearing capacity: 200kg

III .Installation method:

1. Check the fittings. There are 1 service creeper and a set of wheels (there are 6 wheels and a set

of screws inside.) .

2. Install as shown in the figure:

Part List

Note: Please make sure that every screw can be tightened when installing. Do not use the service

creeper with less screws or wheels, so as to avoid the damage of the service creeper caused by the

uneven force on each wheel

IV. Maintenance

1. Try to avoid wind, rain and sun exposure, which will accelerate the aging of plastics

2. When used in extremely cold and hot areas, please clean it in time after use, and try to use it at

normal temperature to avoid freezing cracking or high temperature aging.