INSTRUCTIONS
WALL MOUNT
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Min 90 °C SUPPLY CONDUCTORS.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.
WARNING: Do not use an electric generator to test LED xtures.
CAUTION: For proper weatherproong function, all gaskets must be seated properly and all screws inserted and tightened.
This is important with an uneven wall surface. Silicone all plugs and unused conduit entries.
For wet location compliance, xture must be properly sealed. For moisture seal, apply silicone caulking between the
mounting surface and back housing, as well as around the sides of the housing. This is important with uneven wall surface.
SLIM17 FA 15-30W
Housing Screw (1)
Housing
1) ScrewHousing Fig. 1
Housing Cover Fig. 2
1) Screw tHousing Back Plate
Housing Fig. 3, 4
Housing Back PlateFig. 5
Foam Gasket (provided)Housing Back Plate
Housing Back Plate
Fig. 6
Housing Back Plate Fig. 7
Housing Back Plate(supplied
by others) Screws (supplied by others)
Housing
Fig. 13
Housing Housing Back Plate Screw
(provided) Fig. 8.
Housing Cover (1) Screw
Fig. 1
ConduitSide Conduit Cap
Fig. 2
Housing
Fig. 13
Housing Cover
Conduit