Assembly Instructions for Model: AFMini
Thank you for choosing the Sanus Systems Model AFMini. Every effort has
been made to ensure that your Sanus Systems furniture is perfect. If you have
questions or feel that there is a problem of any kind, please contact us at
800-359-5520 or at www.sanus.com. We can quickly help with any issues
regarding assembly or missing parts. Replacement parts for Sanus systems
products purchased through authorized dealers will be shipped directly to you.
Supplied Parts List:
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 2.13.06 (100002)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Short Pillar - A
Qty. 4
Front Pillar - B
Qty. 2
Rear Pillar - C
Qty. 2
Threaded Rod - D
Qty. 4
CD Rod - E
Qty. 3
Plastic Disk - J
Qty. 16
Equipment Platform - F
Qty. 1
Base - H
Qty. 1
Left Speaker Shelf - G
Qty. 1
Right Speaker Shelf - I
Qty. 1
Top Cap - L
Qty. 4
Rubber Foot - K
Qty. 4
Allen Key - M
Qty. 1
NOTE: You will assemble this product upside down. The Equipment Platform (F) has threaded metal inserts, this distinguishes
it from the Base (H). Lay the Equipment Platform face down on a soft surface with the threaded inserts facing up and the square
edge facing away from you.
Step 1 - Threaded Rod into Base
Thread the four Threaded Rods (D) into the metal inserts in the Base (H).
Diagram 1
D
D
H
H
Step 2 - Slide Plastic Disk and Short Pillars over Threaded Rods
Slide a Plastic Disk (J) with its at side facing down over each Threaded Rod (D).
Slide a Short Pillar (A) over each Threaded Rod (D) so that it is seated in the Plastic Disk (J).
Slide another Plastic Disk (J) with its at side facing up over each Threaded Rod (D) so that it seats on top of each Short
Pillar (A).
Diagram 2
D
J
A
J
Step 3 - Install Speaker Shelves
NOTE: Make sure the rounded edges of the two Speaker shelves (G & I) are facing down and the square edges are
towards the rear.
Slide the Right Speaker Shelf (I) over two Threaded Rods (D) so that the hole for the CD Rod is towards the center of the
AFMini.
Slide the Left Speaker Shelf (G) over two Threaded Rods (D) so that the hole for the CD Rod is directly opposite the CD
Rod hole on the Right Speaker Shelf (I).
Use a book, tissue box, or VHS tape to support the Right and Left Speaker Shelves (I & G) and keep them from drooping.
Diagram 3
G
I
D
I
CD Rod hole
3.5″
[88.9 mm]
4″
[101.6 mm]
Step 4 - Slide Plastic Disk, Front Pillars, and Rear Pillars over Threaded Rods
Slide a Plastic Disk (J) with its at side facing down over each Threaded Rod (D).
NOTE: The Front and Rear Pillars (B & C) are distinguishable by the fact that the 1/4″ [6.4 mm] hole for the CD Rods
in each Front Pillar (B) is 3.5″ [88.9 mm] from the end and the hole in each Rear Pillar (C) is 4″ 101.6 mm] from the
end.
Slide a Front Pillar (B) over the two front Threaded Rods (D), so they are seated in the Plastic Disk (J).
Slide a Rear Pillar (C) over the two rear Threaded Rods (D), so they are seated in the Plastic Disk (J).
Slide another Plastic Disk (J) with its at side facing up over each Threaded Rod (D) so that it seats on top of the Front and
Rear Pillars (B & C).
Diagram 4
B
C
J
D
J
C
B
C
B
FRONT
Step 5 - Install CD Rods
Install a CD Rod (E) into the holes in the rear of the Left and Right Speaker Shelves (G & I).
Install a CD Rod (E) into the holes in the Front and Rear Pillars (B & C).
Diagram 5
E
B
G
C
C
B
I
Step 6 - Attach Base and Rubber Feet
NOTE: The holes in the Base (H) are toward the back.
Align the Base (H) as shown in Diagram 6A; then, place the Base onto the Front and Rear Pillars (B & C) and over the
Threaded Rods (D).
CAUTION: Do not over tighten the Top Caps (L). Over tightening will damage the threads,
Thread a Top Cap (L) onto each Threaded Rod (D); then, using the Allen Key, tighten the Top Caps to secure the Base (H)
to the Front and rear Pillars (B & C) as shown in Diagram 6A.
Remove the backing material from the four Rubber Feet (K) to expose the adhesive on them; then, attach a Rubber Foot to
each corner of the Base (H) as shown in Diagram 6B.
Diagram 6A Diagram 6B
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 2.13.06 (100002)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
K
C
B
B
H
L
L
C
H
K
D
-
1
-
2
-
3
-
4
-
5
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Sanus Systems VLF220 User manual
-
-
-
Home-Complete SYNCHKG081321 Installation guide
-
-
-
-
-
-
