USER MAINTENANCE
Bulb Replacement
CLOSE
OPEN
To close it hold down the “spring
wings” then insert it into the xture.
INSTALLATION INSTRUCTIONS
1. Pull the cord through the bottm part of the strain relief, canopy, and upper
part of the strain relief.
4. Mount the mounting strap onto the outlet box, (The ground screw should
face out).
5. Trim the excess wire to min. 6” beyond stem.
6. Fasten the green or bare copper wire with ground screw provided.
7.7. Fasten the white fixture wire to the white wire in the outlet box. Use extra
white cord given to fasten joined wires as shown in the image. Fasten the
wires to together with the given wire nuts.
Starting about 1” below the fastener, tightly wrap connection with electrical
tape so that the tape seals the end of the fastener.
Make sure that there is no exposed wire or strands that could cause a
dangerousshort circuit !
8. Connect the black fixture wires to the black wire in the outlet box.8. Connect the black fixture wires to the black wire in the outlet box.
Use extra black cord given to fasten the joined wire as shown.
9. Position and mount canopy to outlet box on ceiling by twisting finial cap.
10. Install the lamp.
11. Restore power to circuit at breaker or fuse box.
This product must be installed in accordance with the applicable installation code
by a person familiar with the construction and operation of the product and the
hazards involved.
/
