George Kovacs P1353-618 Installation guide

Type
Installation guide

George Kovacs P1353-618 is a light fixture that can be mounted on a wall or ceiling. It comes with a mounting plate, screws, and drywall anchors for easy installation. The fixture has a ground wire that should be connected to a ground wire in the outlet box, or directly to the mounting plate using the green screw provided. The fixture can accommodate up to three 75W Xenon bulbs, which are included with the fixture. The glass shade is twisted to secure it to the socket cup. The fixture is suitable for use in both residential and commercial settings.

George Kovacs P1353-618 is a light fixture that can be mounted on a wall or ceiling. It comes with a mounting plate, screws, and drywall anchors for easy installation. The fixture has a ground wire that should be connected to a ground wire in the outlet box, or directly to the mounting plate using the green screw provided. The fixture can accommodate up to three 75W Xenon bulbs, which are included with the fixture. The glass shade is twisted to secure it to the socket cup. The fixture is suitable for use in both residential and commercial settings.

INSTALLATION INSTRUCTIONS
Item#P1353-618 (New. 10/26/2017)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
MOUNTING THE FIXTURE (Fig.1)
1.
Shut off the power at the circuit breaker and remove
the old fixture, including the mounting hardware.
2. Carefully remove the fixture fr
om the carton and check
that all parts are included as shown in the illustration.
3. Position mounting plate (A) on the wall, and mark
the
location of two drywall anchors (B). Pre-drill the hole
s
for the drywall anchors (B). Insert the dry
wall anchors
(B) into the wall.
4. Attach the mounting plate (A) to the junction box using
the mounting screws (D)
. The side of the mounting
plate (A) marked “GND” must face out.
5. Place the woodscrews (C) through
the keyhole into the
drywall anchor (B) to secure the mounting plate (A
) as
shown in Fig.1.
CONNECTING THE WIRES (Fig. 2)
6.
At this point, connect the electrical wires as shown in
Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green or
bare copper), connect the fixture’s ground w
ire to it.
Otherwise, connect the fixture’s ground w
ire directly to
the mounting plate using the green s
crew provided.
After the wires are connected,
tuck them carefully
inside the junction box.
FINISHING THE INSTALLATION (Fig.1)
7. Place fixture body (F) over mounting plate (A) and
fasten with screws (E).
8. Secure rod (G) onto the nipple (K
) of the fixture body
(F).
9. Install the 3*75W Xenon bulb (H) (included)
in
accordance with the fixture’s specifications.
(DO NOT
EXCEED THE MAXIMUM WATTAGE RATING!). (
NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
10. Place the glass shade (I
) over the socket and twist to
secure it to the socket cup (J).
Your installation is now complete. Return power and
test the fixture.
Note: Illustration (Fig.1) on this manual is f
or
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-2874E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Set#
-
Mounting Screw*2
-
Ground Screw
-
Mounting Plate
C
F
G
H
I
D
J
K
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
  • Page 1 1

George Kovacs P1353-618 Installation guide

Type
Installation guide

George Kovacs P1353-618 is a light fixture that can be mounted on a wall or ceiling. It comes with a mounting plate, screws, and drywall anchors for easy installation. The fixture has a ground wire that should be connected to a ground wire in the outlet box, or directly to the mounting plate using the green screw provided. The fixture can accommodate up to three 75W Xenon bulbs, which are included with the fixture. The glass shade is twisted to secure it to the socket cup. The fixture is suitable for use in both residential and commercial settings.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI