MGA Entertainment Project MC2 Circuit Beats User manual

Brand: MGA Entertainment

Model: Project MC2 Circuit Beats

Category: Learning toys

Type: User manual

539247

Illustrations are for reference only. Styles may vary from actual contents.

CONTENTS

A. 1 Speaker Headband

B. 1 Circuit Board Controller

C. x7

ADULT SUPERVISION REQUIRED

6+ YEARS

CIRCUIT BEATS™

ITEMS YOU WILL NEED (NOT INCLUDED)

Have an adult help you gather all the household items needed and supervise during the experiment.

You can use any object that contains moisture such as:

C. 7 Wires with Clips

D. 1 Sticker Sheet

Banana

Flower In Water

A Friend’s Arm

Strawberry

Ice Cream

Orange Slice

The batteries included in Circuit Beats™ are for in-store demonstration. Before playing an ADULT

must install fresh alkaline batteries. Here’s how:

1. Remove the pull tab undeneath the circuit board controller and discard.

2. Using a Phillips screwdriver (not included) loosen the screw and remove the battery

compartment cover from the bottom of the controller.

3. Install three (3)1.5V (LR03)AAA alkaline batteries (not included) making sure the (+) and (-) ends

face the proper direction as indicated inside the battery compartment.

4. Replace the compartment cover and tighten the screw.

BEFORE YOU BEGIN

3 x 1.5 V

AAA (LR03) Batteries

1.5V AAA/LR03

pull tab

SETTING UP YOUR CIRCUIT BEATS™

NOTE: Before beginning, cover the play area to avoid possible damage from food spillage.

Unplug the cable from the right side of the controller.

Put on the speaker headband and plug it into the port on the top left side of the controller.

Plug in one wire into the grounding wire port on the bottom left side of the controller.

Plug the remaining six wires into the ports on the front of the controller.

Connect the clip on the end of the grounding wire to your index finger. Then, connect the remaining clips to

objects that conduct electricity. These are usually things that hold moisture. What else can you try?

Go to YouTube.com for more ideas!

Please keep this manual as it contains important information.

www.projectmc2.com

PROJECT MC

™

is a trademark of MGA

in the U.S. and other countries. All

logos, names, characters, likenesses,

images, slogans, and packaging

appearance are the property of MGA.

16300 Roscoe Blvd.

Van Nuys, CA 91406 U.S.A.

(800) 222-4685

Printed in China

MGA Entertainment UK Ltd.

50 Presley Way

Crownhill

Milton Keynes, MK8 0ES

Bucks, UK

+ 0800 521 558

Visit

.com

to register your product

and to enter our sweepstakes

(No purchase necessary)

Watch on:

Download the free app:

Kids, ask your parents to download the Project Mc

™

app, available on iOS devices through the app store :

• Click on the App Store icon on your iOS device.

• Click “Search” on your mobile device and type in “Project Mc2”

• Once the correct app name comes up on the screen, tap on the word “get.”

• You may be asked for your Apple ID. If so, enter your ID or follow the instructions on screen to get one.

• Once your ID is accepted, watch the download status until the download is complete.

• The application icon should appear on your device. Tap the icon to activate the app.

The Project Mc

™

app requires iOS 6.1 or later. Compatible with iPod Touch® 4, iPhone® 4 and iPad® 2 or

later versions. Data rates may apply.

0915-0-E/INT

‘Let’s care for the environment!’

The wheelie bin symbol indicates that the product must not be disposed of with other household waste. Please use

designated collection points or recycling facilities when disposing of the item.

Do not treat old batteries as household waste. Take them to a designated recycling facility.

FCC COMPLIANCE

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Caution: Modifications not authorized by the manufacturer may void users authority to operate this

device.

CAN ICES-3 (B)/NMB-3(B).

• Use alkaline batteries for best performance and longer life.

• Use only the type battery recommended for the unit.

• Batteries should be replaced only by an adult.

• Insert batteries with the correct polarity ( + and – ).

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc), or rechargeable(nickel-cadmium) batteries.

• Do not short-circuit batteries.

• When not used for an extended time, remove batteries to prevent possible leakage

and damage to the unit.

• Do not mix rechargeable and non-rechargeable batteries.

• Rechargeable batteries are to be removed from the toy before charging.

• Rechargeable batteries are to be recharged only under adult supervision.

• Do not recharge non-rechargeable batteries.

• Exhausted batteries are to be removed from the toy.

• Do not dispose of batteries in fire as they may leak or explode.

SAFE BATTERY USAGE

MAKING MUSIC

IMPORTANT INFORMATION

Move the switch to “ON” underneath the controller.

OFF

press and hold to record

speak into the mic

You can record up to three seconds of your own sound! Press and hold the “REC.” button to record

your beat. Speak into the mic, and then release the “REC.” button. To make a new sound, record

again by repeating these steps.

NOTE: The controller will not save your previous beats once you record over them.

Choose a sound by pressing the buttons in the middle of the controller.

PIANO

GUITAR

DRUMS

CAT MEOW

YOUR RECORDING

With your finger connected to the grounding wire, use your other hand to tap on the

connected objects. Sound will play from your headband speakers! To play different keys,

follow the numbers indicated above. The highest key is port 6 and the lowest is port 1.

Tip: Some items, like bananas, might need extra moisture before they make sound. Try

wetting the area under the clip with water, and then play notes!

• Remove all cables from the controller after use and rinse thoroughly with water to

remove residue from objects. Air dry only.

• DO NOT insert wet wires into the controller.

• DO NOT immerse the headband or controller in water.

• Move the switch underneath the controller to the “OFF” position after use to conserve

battery power.

• DO NOT eat any items used during experimentation. Dispose of food items immediately

after use.

MGA Entertainment Project MC2 Circuit Beats User manual

Brand: MGA Entertainment

Model: Project MC2 Circuit Beats

Category: Learning toys

Type: User manual

Download PDF

report

MGA Entertainment Project MC2 Circuit Beats User manual

MGA Entertainment Project MC2 Circuit Beats User manual

Related papers

Other documents