2. Computers & electronics
  3. Audio & home theatre
  4. AV equipment stands
  5. TOA
  6. HY-MT7

TOA HY-MT7 User manual

  • Hello! I am an AI chatbot trained to assist you with the TOA HY-MT7 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1. SAFETY PRECAUTIONS
• Beforeinstallationoruse,besuretocarefullyread
all the instructions in this section for correct and
safeoperation.
• Besuretofollowalltheprecautionaryinstructions
in this section, which contain important warnings
and/orcautionsregardingsafety.
• After reading, keep this manual handy for future
reference.
• Donotuseothermethodsthanspeciedtomount
theadapter.Extremeforceisappliedtotheadapter
andthematchingtransformercouldfalloff,possibly
resultinginpersonalinjuries.
• Tighten each nut and bolt securely. Ensure that
the adapter has no loose joints after installation
to prevent accidents that could result in personal
injury.
• Use the specied matching transformer in
combination. Doing otherwise may cause the
adapterormatchingtransformertofalloff,resulting
inpersonalinjury.
• Avoidinstallingthespeakerinlocationsclosetothe
seashore or in indoorswimming facilities that are
not well ventilated. In such locations, the adapter
maybevulnerabletocorrosion,eventuallyallowing
thematchingtransformertofallresultinginpersonal
injury.
Indicatesapotentiallyhazardoussituationwhich,
ifmishandled,couldresultinmoderateorminor
personalinjury,and/orpropertydamage.
CAUTION
• Avoidtouching the adapter’s sharp metal edgeto
preventinjury.
• Havetheadaptercheckedperiodicallybytheshop
from where it was purchased. Failure to do so
mayresult in corrosion or damageto the adapter
that could cause the matching transformer to fall,
possiblycausingpersonalinjury.
2. GENERAL DESCRIPTION
The HY-MT7 Matching Transformer Adapter is
designed to mount an optional MT-200 Matching
Transformer*totheHX-7SeriesSpeakerSystem.
* The Matching Transformer is used to convert low
impedancetohighimpedance(100Vor70Vline).
Refer to the MT-200’s Operating Instructions for
moredetails.
3. MT-200 MOUNTING ExAMPLE
Note
When joiningtwospeakersystems, aseparateMT-
200 Matching Transformer must be attached to the
secondspeakersystemaswell.Themountingmethod
isthesameasthatfortheinitialspeakersystem.
INSTALLATION MANUAL
MATChING TRANSFORMER ADAPTER hY-MT7
ThankyouforpurchasingTOA’sMatchingTransformerAdapter.
Pleasecarefullyfollowtheinstructionsinthismanualtoensurelong,trouble-freeuseofyourequipment.
Indicatesapotentiallyhazardoussituationwhich,
if mishandled, could result in death or serious
personalinjury.
WARNING
MT-200
HX-7 Series speaker
Step 1. RemovetheMT-200’scover.
Step 2. Changetheprimaryconnectiontap.
ThetapoftheMT-200isfactory-presetto167Ω.
Changethesettingasrequired.
To change the tap, reconnect the primary black cord
accordingtothetablebelow.

Tap
Line
25Ω 50Ω 83Ω 167Ω
100Vline
–
200W 120W 60W
70Vline 200W 100W 60W 30W
Note: NevertouchthewhitecordconnectedtotheCOMtap.
4. MOUNTING ThE MT-200 MATChING TRANSFORMER
BeforemountingtheMT-200,layoutaprotectivesheet,corrugatedcardboardorothersoftmaterialonaat
surface,andperformallworkonthespeakerwithitsfrontbafefacingdownward.
Speaker module
Speaker system
Note
Each HX-7 Series Speaker System
consists of four speaker modules.
Tightentheboltssecurely,asinstructedbelow.
Failuretofollowinstructionspreciselycouldresultinafallingspeaker
andpotentialpersonalinjury.
• Ensurethatallboltsaresecurelyinsertedasfarastheirthreadsgo,
thensecurelyfasteneachboltwithanut.
• Tighten all the bolts with the designated tightening torque. For
tightening,useaPhillipsscrewdriver,oropen-orbox-endwrench.
WARNING
Cover
Cover fixing screw
MT-200
COM
25Ω 50Ω 83Ω167Ω
White (–)
Black (+)
Step 3. MounttheMT-200tothisadapter.
Mount the MT-200 as shown in the gure at
right.Itscompletedinstallationisshowninthe
“MT-200MountingExample”gureonthefront
page.
Tip
BesuretokeeptheMT-200’scoverremoved.
Note
Wheninstallingspeakersystemsundereaves,
besuretoinstallinaverticalarray.Further,to
ensure the MT-200’s waterproong capability,
install it so that its top panel surface is tilted
within45ºoftheverticalplane.
If the MT-200’s waterproong capabilities
cannot be ensured by the mounting method
shown in the gure at upper right, mount the
MT-200asshownatlowerright.
Refertotheoperatinginstructionssuppliedwith
theMT-200.
MT-200 (without cover)
This adapter
Tightening torque:
8 N·m
Hex head bolt (supplied
with the MT-200)
Plain washer for M8
(accessory)
Nut for M8
(accessory)
Step 4. Mountthisadaptertotherearpanelofthespeakermodule.
This adapter can be attached to any
speaker module, however there may be
cases in which they cannot be easily
attached due to their combination with
otheroptionalmountingbrackets.Insuch
cases, attach this adapter to any free
speakermodule.
This adapter
Hex head bolt M6 x 16
(with spring and plain
washers, accessory)
Tightening
torque: 3 N
·m
MT-200
45°
45°
UP
Top surface
MT-200 (without cover)
Tightening torque:
8 N·m
Hex head bolt (supplied
with the MT-200)
This adapter
Plain washer for M8
(accessory)
Nut for M8
(accessory)
Step 5. ConnectthelinesfromtheMT-200tothespeaker’srear-mountedconnector.
Forcableconnection,refertotheMT-200’sandtheHX-7Seriesspeaker’sOperatingInstructions.
Step 6. ReplacetheMT-200’scoverandtightenthescrews.
Securetheremovedcoverwiththe2coverfixingscrews.
Note
Toensurethesplash-proofcapability,pressthecoverrmlyontothegasket.
URL:http://www.toa.jp/
133-01-00038-00
5. SPECIFICATIONS
ApplicableSpeaker HX-7B,HX-7W,HX-7B-WP,HX-7W-WP
Finish Stainless,black,semi-gloss,paint
Dimensions 30(w)x70(h)x28(d)mm(1.18"x2.76"x11.02")
Weight 140g(0.31lb)
Note:Thedesignandspecicationsaresubjecttochangewithoutnoticeforimprovement.
• Accessories
HexheadboltM6x16withspringandplainwashers....... 4
PlainwasherforM8............................................................ 2
NutforM8........................................................................... 2
/