Following table shows set-points level:
GUIDE TO SELECTING FUNCTIONS
FAST COOLING
The use of this function is recommended when placing a very high quantity
of food in the refrigerator compartment
By pressing and hold the pushbutton on the control panel for 3 sec. it is
possible to increase the cooling speed of the foods inside the refrigerator
compartment. The Fast Cooling light ( yellow LED) will turn on. The
function is automatically deactivated after 6 hours.
The Fast Cooling function can be manually deactivated by pressing and hold
the same pushbutton on the control panel for 3 sec., the yellow LED is off.
Note:
- Fast Cooling function should be also switched ON before placing fresh
food to be frozen in the freezer compartment.
- Fast Cooling function has to be engaged in order to maximize freezing
capacity, thus it has to be engaged before to add fresh
ECO GREEN (depending on the model)
This function gives best food preservation performance with the smallest
energy consumption possible (around 5-10% less in comparison with the
normal settings - middle temperature ) if there is lower amount of food to
be preserved in the appliance.
When ECO GREEN function is activated only these ECO compartments
should be used in order to have the perfect food preservation:
- 2 "eco green" shelves in the fridge (with green frames)
- 1 "eco green" basket in freezer compartment
To active the Eco Green function press the pushbutton on the control panel
to choose the mid–high temperature, as showed here below:
NIGHT TARIFF
Night Tariff function allows one to concentrate the energy consumption of
the product during off-peak time (usually coinciding with night time), when
energy is available in large quantity and it costs less than during the day (only
in specific countries using multiple-rate system based on off-peak times -
check your rate plan with your utility company). To activate the function,
press the pushbutton for 3 sec. at the starting moment of the off-peak rate
(depending on your specific rate plan). For example, if the off-peak rate
starts at 20:00, you have to press the pushbutton for 3 sec. at that time.
To activate the function, press the pushbutton for 3 sec. at the starting
moment of the off-peak rate (depending on your specific rate plan). For
example, if the off-peak rate starts at 20:00, you have to press the
pushbutton for 3 sec. at that time. When the Night Tariff LED is ON, the
function is active.
After you activate the function, the product automatically starts to adapt the
energy consumption to the time, i.e. consuming less energy during the day
then during the night.
IMPORTANT: In order to work in a correct way, the function must be
active both during the night and the day.
The feature remains active until you deactivate it (or if a blackout occurs, or
if the product is switched off). To deactivate the function, press the
pushbutton again for 3 sec. When the Night Tariff LED is OFF the function
is not active.
Note: appliance energy consumption is declared with "NIGHT TARIFF"
function disabled.
ABNORMAL APPLIANCE OPERATION
When the product is plugged in to the mains, during first 10 minutes of its
performance, possible temperature sensor failure will be displayed
according to following table:
The appliance will work preserving the food stored, but it is The appliance
will work preserving the food stored, but it is necessary to contact after-
sales service and provide alarm code.
DEFROSTING THE FREEZER COMPARTMENT
No Frost freezers provide chilled air circulation around the storage areas and
prevent the formation of ice, thereby completely eliminating the need for
defrosting. Frozen items don't stick to the walls, labeling stays legible and
storage space remains neat and clear.
DEFROSTING THE REFRIGERATOR COMPARTMENT
Refrigerator compartment defrosting is completely automatic.
Droplets of water on the rear wall inside the refrigerator compartment
indicate that the automatic defrost phase is in progress. The defrost water
is automatically run into a drain hole and collected in a container, where it
evaporates.
REPLACING THE LIGHT (depending on the model)
BULB's LIGHTING
Always disconnect the refrigerator from the
power supply before replacing any light bulb.
If the inside light is not working, it is
necessary to:
1. Remove the light cover: put the fingers
into the side ventilation holes (1), stretch
the cover gently and move it upwards.
2. Check the bulb. If necessary unscrew the
broken bulb and replace it with the new
one (max power of the light bulb is given
on the light cover).
3. Put on the light cover.
Do not leave the bulb uncovered.
LED's LIGHTING
If the inside LED light is not working, it must be replace by service.
High temperature
Mid-high temperature
(Eco Green)
Middle temperature
Mid-low temperature
Low temperature
Eco Green
Fast cooling
Legend
Led ON
Led ON
Legend
Led ON
Led ON
Refrigerator Evaporator
sensor failure
Refrigerator sensor failure
Refrigerator & Evaporator
sensor failure
FINDKNSGRIPENLFGBD
5019 637 01091
Printed in Poland 01/11
PRODUCT SHEET
GB
Legend
Led ON
Led ON
Night Tariff
ON
Night Tariff
OFF
Legend
Led OFF
Led Flashing