Accelerated NetBridge Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the Accelerated NetBridge Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Technical Support
If you are having problems installing any of our products and need
technical assistance, please call or email our help desk.
 +1 (813) 699-0295
 Support hours are 9am to 5pm EST
NetBridge Quick Start Guide
Unpacking the NetBridge
Each NetBridge package contains the following items:
 NetBridge
 Quick Install Guide
 12v Power Adapter
 12v Temporary Battery
 Ethernet Cable
 Power over Ethernet (PoE) Cable (PoE cable)
Corporate and Sales Headquarters
Accelerated Concepts
4017 W. Martin Luther King Jr. Blvd
Tampa, FL 33614
Phone: +1 (813) 983-7635
www.acceleratedconcepts.com
Installation Procedure
NetBridge LED Indicators
PoE LED Indicators
Cat 5 Ethernet Cable
Step 1
Insert a single activated USB modem into either the external or internal USB
port. The internal USB port can be accessed by unscrewing the four feet
“thumb screws” on the bottom of the NetBridge.
The USB modem must be on the supported list of devices,
which can be found at http://acceleratedconcepts.com/support
Step 2 Find the optimal NetBridge placement by performing a Site Survey as listed in
Steps 3 thru 5. If a Site Survey has been performed previously, skip to Step 6.
Step 3 Connect the temporary battery pack to the NetBridge
Step 4 Move the NetBridge device to different locations in your facility to find the
optimal location. Note; the strongest cellular signal could be along the
perimeter or near the ceiling.
To obtain an accurate reading, it is recommended the device
remain stationary at each location for at least 30 seconds .
Step 5 Disconnect the temporary battery.
Step 7 If using the PoE Cable to supply the NetBridge with power, connect the male
Ethernet adapter into the “Internet” or “WAN” port of your client device.
(computer, router, etc.) Connect a Standard CAT5 Ethernet cable to the
female end of the PoE Cable. See Diagram A
Step 8 If connecting power directly to the NetBridge, insert a Standard CAT5 cable
into the “Internet” or “WAN” port of your client device. See Diagram B
Step 9 Insert the far end of the Standard CAT5 Ethernet cable into the Ethernet port of
the NetBridge.
It is recommended that the Ethernet cable not exceed 300ft.
USB

Yellow – System start-up (boot sequence)
 Red – No USB modem inserted or unsupported modem
 Green – Supported USB modem inserted
3G

Yellow flashing – Modem dialing network
 Yellow solid – 2G mode
 Red – no network connection
 Green flashing – check USB modem activation
 Green solid – 3G mode.
Signal
Strength

Indicates Cellular signal strength and provides binary codes for
troubleshooting purposes
PoEDC

A lit Red LED indicates DC Power Adapter is connected to
PoE Cable
PoEPWR

A lit Green LED indicates Cat 5 Ethernet Cable is connected to
NetBridge.
/