User manual
8
The temperature knob is adjusted to the maximum
Start the steam switch and move the product
When the steam switch is turned on, the product remains stationary for 3 seconds and the steam is
recovered when the product is moved!
BURST OF STEAM
This function provides an extra amount of steam to remove stubborn wrinkles.
Press the burst button to generate a powerful burst of steam that can penetrate the fabrics and smooth
the most difficult and tough creases. Wait for a few seconds before pressing again
By pressing the burst button at intervals you can use also iron vertically (curtains, hung garments, etc.)
Warning: the shot-steam function can only be used at high temperatures. Stop the emission when the
plate temperature control light comes on, than start ironing again only after the light has gone off.
DRY IRONING
1. Connect the iron to a suitable mains supply outlet.
2. Ensure that the steam knob (4) is on position .
3. Select the setting with temperature knob.
4. When the light turns off, the required temperature is reached. The iron is ready for use.
Spray Function
Make sure that there is water in the reservoir. Press the spray button (6) slowly (for a dense spray) or
quickly (for a vaporized spray)
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. In these cases, the Anti-drip system automatically activates
to prevent vaporization, so that you can iron the most delicate fabrics without risk of spoiling or staining
them.
SELF-CLEANING
The self-cleaning feature cleans inside the plate, removing impurities.
We recommend using it every 10-15days.
1. Fill the reservoir up to the maximum level indicated and set the steam knob (4)
2. Set the thermostat knob to the maximum temperature and wait for the light to turn off.
3. Hold the iron horizontally over the sink, move the steam button cursor to the left. Repeat until all
the boiling water, steam, and impurities come out.
CARE AND CLEANING
1. Turn the temperature control MIN, then disconnect the iron from the wall outlet and let it cool down
completely.
2. Deposits and other residues on the sole plate can be removed with a cloth soaked in a vinegar/water