2. Metal Pro
  3. MP9000

Metal Pro MP9000 Owner's manual

  • Hello, I'm a chat assistant, and I have reviewed the product details for the METALpro MP9000 Pipe Bender. This document describes the bender's specifications, its applications, and its key features, including its ability to bend pipes, rods, and conduits up to 90 degrees. I'm ready to answer any questions you have about the device.
  • What size range of pipe can the MP9000 bend?
    What is the maximum bending angle?
    What type of electrical service is required for the MP9000?
APPLICATIONS
The METALpro MP9000 Bender can be used on a variety of
professional, farm, and industrial production jobs. With dierent dies,
the machine can bend ½" through 2" sch. 40 and 80 pipe up to 90º.
The same dies can also be used to bend solid rod and rigid electrical
conduit up to 90º. Dies for ½" to 2" heavy wall round tubing
are available. Contact us for specic requirements.
BENEFITS
• The most cost eective 90 degree bender on the market
• Wide range of bending applications
– Bends up to 90º sch. 40 and sch. 80 pipe
– For use with solid rod
– Bend rigid electrical conduit
– Bend heavy wall tubing
• Works at any shop or job site with 110V, 20 amp service
• One year warranty
• Made in the Hamilton, MI USA
SPECIFICATIONS
Width ................................26"
Height ...............................43"
Length ...............................27"
Weight ..............................250 pounds
Strokes per minute ...........approximately 4-5 for smallest pipe
Bending force ....................12 tons
Size range .........................½" up to 2" diameter
Maximum bend ..................90º
Motor .................................1½ horsepower
Electrical ............................110V, 20 amp
Hydraulic power ................ self-contained, 2500 PSI
Hydraulic oil capacity ......... 1.5 gallon
MP9000 Bender More metal fabrication for your money
PIPE
ID = Inside Diameter
NPS = Nominal Pipe Size
NPS<14 inches: OD>NPS>ID
Nominal Diameter
TUBE
Tube Dimensions
OD = Outside Diameter
WT = Wall Thickness
Wall Thickness
Centerline Radius
Outside
Diameter
Bend Angle
metalprocorp.com
4715 136th Avenue, Hamilton, MI 49419
(262) 679-0504
TUBE VS PIPE
A tube is a round hollow section measured by outside diameter (OD) and wall thickness (WT)
A pipe is a round tubular designated by a nominal pipe size (NPS or DN) that represents a rough indication of the pipe capacity
December 2022
/