TradeQuip Professional BHSP20T Lubrication Guide

Type
Lubrication Guide

This manual is also suitable for

www.tqbbrands.com.au May21
Press
Lubrication Guide
Product Codes:
1187T BHSP20T BHSP30T
Lubrication Instructions
1. Pivots and pins in all manual pump mechanisms should be lubricated with a Light Bearing Grease or 30/40W
Machine Oil to ensure long life and prevent premature wear.
2. Bed load bearing surfaces should be lubricated with a Light Bearing Grease or
30/40W Machine Oil to ensure long life and prevent premature wear.
3. Bed winch pulleys should be lubricated with a Light Bearing Grease or 30/40W Machine Oil to ensure smooth
operation, long life and prevent premature wear.
4. Periodically extend, clean, and lubricate the ram shaft with silicone lubricant spray to ensure smooth
extension and retraction of the ram.
Periodic maintenance is essential for the efficient operation of Manual and Air over Hydraulic operated Presses.
www.tqbbrands.com.au May21
5. Lubricate the bed pins and upright positioning holes
periodically to ensure easy bed height readjustment.
6. Lubricate the safety guard latches periodically to ensure easy guard height
readjustment.
7. Lubricate Winch mechanicals including Gears, Axle Rods and Ratchet Assemblies.
  • Page 1 1
  • Page 2 2

TradeQuip Professional BHSP20T Lubrication Guide

Type
Lubrication Guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI